CDB4364 Cirrus Logic Inc, CDB4364 Datasheet - Page 7

• Manufacturer Part Number: CDB4364
• Description: Eval Bd 6Chn DAC W/DSD Spt&Lw-Ltnc DF
• Manufacturer: Cirrus Logic Inc

Specifications of CDB4364

• Number Of Dac's: 6
• Number Of Bits: 24
• Outputs And Type: 6, Single Ended
• Sampling Rate (per Second): 192k
• Data Interface: Serial
• Dac Type: Voltage
• Voltage Supply Source: Analog and Digital
• Operating Temperature: -40°C ~ 85°C
• Utilized Ic / Part: CS4364
• Description/function: Audio D/A
• Operating Supply Voltage: 5 V
• Product: Audio Modules
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: CS4364
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant, Contains lead / RoHS non-compliant

DS619F1
FILT+
AOUT1
AOUT2
AOUT3
AOUT4
AOUT5
AOUT6
MUTEC1
MUTEC2
MUTEC3
MUTEC4
MUTEC5
MUTEC6
TST_OUT
Hardware Mode Definitions
M0
M1
M2
M3
M4
Software Mode Definitions
SCL/CCLK
SDA/CDIN
AD0/CS
TST
DSD Definitions
DSD1, DSD2
DSD3, DSD4
DSD5, DSD6
DSD_SCLK
Pin Name
40, 37
36, 33
30, 27
47,46
1, 48
3, 2
20
39
38
35
34
29
28
41
26
25
24
23
22
17
16
15
12
10
15
16
17
10
12
42
#
Positive Voltage Reference (Output) - Positive reference voltage for the internal sampling cir-
cuits. Requires the capacitive decoupling to analog ground as shown in the Typical Connection
Diagram.
Analog Output (Output) - The full scale analog output level is specified in the Analog Character-
istics specification table.
Mute Control (Output) - These pins are intended to be used as a control for external mute circuits
on the line outputs to prevent the clicks and pops that can occur in any single supply system.
Test Output - These pins need to be floating and not connected to any trace or plane.
Mode Selection (Input) - Determines the operational mode of the device as detailed in
and 5.
Serial Control Port Clock (Input) - Serial clock for the serial control port. Requires an external
pull-up resistor to the logic interface voltage in I²C
gram.
Serial Control Port Data (Input/Output) - SDA is a data I/O line in I²C mode and is open drain,
requiring an external pull-up resistor to the logic interface voltage, as shown in the Typical Con-
nection Diagram; CDIN is the input data line for the control port interface in SPI
Address Bit 0 (I²C) / Control Port Chip Select (SPI) (Input) - AD0 is a chip address pin in I²C
mode; CS is the chip select signal for SPI mode.
Test - These pins need to be tied to analog ground.
Direct Stream Digital Input (Input) - Input for Direct Stream Digital serial audio data.
DSD Serial Clock (Input) - Serial clock for the Direct Stream Digital serial audio interface.
Pin Description
®
mode as shown in the Typical Connection Dia-
™
mode.
CS4364
Tables 4
7