C500TS502 Omron, C500TS502 Datasheet - Page 13

• Manufacturer Part Number: C500TS502
• Description: RTD INPUT MODULE
• Manufacturer: Omron

Specifications of C500TS502

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Indicators and RS-232C Connector
2- -4
Indicators and RS-232C Connector
Note: The RS-232C connector is used by the factory for configuring the module.
The indicator lights and the RS-232C connector are located behind the indi-
cator cover. To access this area of the module, remove the indicator cover by
rotating it clockwise or counterclockwise until the cover is free, then lift the
cover off. The indicators allow the operator to monitor the status and opera-
tion of the module. Refer to the chart which describes each indicator function.
Refer to the illustration to identify and locate the indicators and the connector.
Indicators
RUN (Green)
ERROR (Red)
RANGE (Red)
COM ERR (Red)
T/R (Orange)
TS502
Indicator
cover
Function
When the indicator is illuminated, the microprocessor is
operating correctly.
When the indicator is illuminated, an internal module
diagnostic failure, an out-of-range error, or a communication
error has occurred.
When the indicator is illuminated, an input signal is outside
the selected range. This condition occurs when an enabled
input point is not connected to an RTD, or the temperature
has gone above or below the specific range.
When the indicator is illuminated, a communication error has
occurred when communicating over the serial port.
When the indicator is illuminated, communication is occurring
over the serial port.
Indicator cover
removed
Indicators
2/4 word
mode jumper
RS-232C
connector
RUN (Green)
ERROR (Red)
RANGE (Red)
COMM ERR (Red)
T/R LIGHT (Orange)
Section 2- -4
7