C500TS502 Omron, C500TS502 Datasheet - Page 18

• Manufacturer Part Number: C500TS502
• Description: RTD INPUT MODULE
• Manufacturer: Omron

Specifications of C500TS502

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Wiring the Module
3- -3
12
Wiring the Module
Note: Make settings to the rotary switch and to its corresponding jumper block for
3.
the designated input point. In the back of the module, the rotary switch lo-
cated nearest to the top of the module is designated rotary switch number 1
and corresponds to Input Point 1. The bottom rotary switch corresponds to
Input Point 8. Rotary switch position 0 and positions 4 through 9 are non-
functional.
4.
5.
6.
Wiring is accomplished at the terminal connectors or also referred to as ter-
minal blocks. To access the terminal connectors proceed as follows.
1.
2.
3.
4.
Back of module
Rotary switches
Set each jumper and rotary switch for the selected input point. The left
jumper in each jumper block selects the RTD type. The right jumper se-
lects the wiring configuration.
After making settings, record the module settings in the Configuration
Sheet in Appendix D.
Reinstall the module to the backplane. Make sure that it seats in the
backplane slot.
Install the terminal block cover.
Remove the front cover.
Insert each wire in the appropriate connector.
Secure each wire with the terminal screw.
Replace the front cover.
Input point #1
Input point #2
Input point #3
Input point #4
Input point #5
Input point #6
Input point #7
Input point #8
Jumpers
I1
+IN
COM
I2
I1
+IN
COM
I2
I1
+IN
COM
I2
I1
+IN
COM
I2
I1
+IN
COM
I2
I1
+IN
COM
I2
I1
+IN
COM
I2
I1
+IN
COM
I2
Section 3- -3
Input
point #1
Input
point #2
Input
point #3
Input
point #4
Input
point #5
Input
point #6
Input
point #7
Input
point #8