R88A-CSU010C Omron, R88A-CSU010C Datasheet - Page 98

no-image

R88A-CSU010C

Manufacturer Part Number
R88A-CSU010C
Description
ABSOLUTE ENCODER CABLE,10M
Manufacturer
Omron
Datasheet

Specifications of R88A-CSU010C

Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Design and Installation
j Noise Filters
Ground the motor’s frame to the machine ground when the motor is on a movable shaft.
Connect the frame ground for each Unit as shown in the diagram and using ground lines as short as
possible.
If no-fuse breakers (MCCB) are installed at the top and the power supply line is wired from the lower
duct, use metal tubes for wiring or make sure that there is adequate distance between the input lines
and the internal wiring. If input and output lines are wired together, noise resistance will decrease.
No-fuse breakers (MCCB), surge absorbers, and noise filters (NF) should be positioned near the input
terminal block (ground plate), and I/O lines should be isolated and wired using the shortest means
possible.
Remove the coating (or mask when coating) from the panel area to which the Position Driver and noise
filters are mounted to improve electrical conductivity.
Locate noise filters as close to the Position Driver as possible and keep the wiring distance between
the noise filters and Position Driver as short as possible.
Ground (100
Note 1. The cable winding for the ferrite core must be 1 turn.
Note 2. Remove the sheathes from the cables at the clamps and ground them directly to the metal
Note 3. For DIO Position Drivers, remove the sheath from control cables and connect the shield
FND-X50H-
All Position Drivers
AC power
supply
Metal
duct or
conduit
max.)
plate at the clamps.
directly to the metal plate. For CompoBus/S Position Drivers, place the control cables in
metal ducts or conduits and connect the duct or conduit directly to the metal plate.
Control panel
Metal plate
NFB
Position Drivers
Grounding plate
Surge
absorber
Controller
power
supply
DIO:
CompoBus/S: 100 m max.
Driver FG
Controller
Noise
filter
5 m max.
0.5 m
max.
Contactor
Brake pow-
er supply
Controller
Ferrite
core
Clamp
Clamp
Protectively
separated
Ferrite
core
Clamp
0.5 m
max.
0.5 m
max.
Ferrite
core
Metal
duct or
conduit
Device containing Servomotor
R88M-U conforming
to EC Directives
Chapter 2
2-75

Related parts for R88A-CSU010C