HSDL-3208-021 Lite-On Electronics, HSDL-3208-021 Datasheet - Page 18

• Manufacturer Part Number: HSDL-3208-021
• Description: Infrared Transceivers IR Transceiver 115Kb/s
• Manufacturer: Lite-On Electronics
• Type: TX/RXr

Specifications of HSDL-3208-021

• Wavelength: 875 nm, 880 nm
• Continual Data Transmission: 115.2 Kbit/s
• Radiant Intensity: 8 mW/sr
• Half Intensity Angle Degrees: 30 deg to 60 deg
• Pulse Width: 4 us, 1.6 us
• Maximum Rise Time: 50 ns, 600 ns
• Maximum Fall Time: 50 ns, 600 ns
• Led Supply Voltage: 0 V to 6.5 V
• Maximum Forward Current: 50 mA
• Operating Voltage: 2.4 V to 3.6 V
• Maximum Operating Temperature: + 70 C
• Minimum Operating Temperature: - 25 C
• Dimensions: 7.4 mm x 2.9 mm x 1.8 mm
• Data Rate: 115.2Kbps
• Peak Wavelength: 875/880nm
• Angle Of Half Sensitivity: 60/30°
• Fall Time: 600/50ns
• Rise Time: 600/50ns
• Operating Supply Voltage (typ): 2.5/3.3V
• Operating Supply Voltage (min): 2.4V
• Operating Supply Voltage (max): 3.6V
• Mounting: Surface Mount
• Pin Count: 7
• Operating Temp Range: -25C to 70C
• Operating Temperature Classification: Commercial
• Idle Current, Typ @ 25° C: 100µA
• Link Range, Low Power: 30cm
• Operating Temperature: -25°C ~ 70°C
• Orientation: Side View
• Shutdown: *
• Size: 7mm x 2.8mm x 1.6mm
• Standards: IrPHY 1.4
• Supply Voltage: 2.4 V ~ 3.6 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

18
Appendix C : General
Application Guide for the
HSDL-3208 Infrared IrDA
Compliant 115.2 kb/s
Transceiver
Description
The HSDL-3208 is an ultra-small
low-cost infrared transceiver
module that provides the interface
between logic and infrared (IR)
signals for through air, serial,
half-duplex IR data link. The
device is designed to address the
mobile computing market such as
PDAs, as well as small embedded
mobile products such as digital
cameras and cellular phones. It is
Figure 27. IR layout in mobile phone platform.
DE-MODULATOR
TRANSCEIVER
MOD/
MICROPHONE
SPEAKER
®
AUDIO INTERFACE
USER INTERFACE
RF INTERFACE
fully compliant to IrDA 1.4 low
power specification from 9.6 kb/s
to 115.2 kb/s, and supports HP-
SIR and TV Remote modes. The
design of the HSDL-3208 also
includes the following unique
features:
• Low passive component count
• Shutdown mode for low power
Selection of Resistor R1
Resistor R1 should be selected to
provide the appropriate peak
pulse LED current over different
ranges of V
table below.
Recommended R1
30
consumption requirement
CC
as shown in the
MICROCONTROLLER
V
3.3 V
CC
DSP CORE
Intensity
9 mW/Sr
Interface to Recommended I/O Chips
The HSDL-3208’s TXD data input
is buffered to allow for CMOS
drive levels. No peaking circuit or
capacitor is required.
Data rate from 9.6 kb/s up to
115.2 kb/s is available at the RXD
pin.
The diagram below shows how
the IR port fits into the mobile
phone platform and PDA
platform.
CONTROLLER
IR
ASIC
HSDL-3208
Minimum Peak Pulse
LED Current
50 mA