KMA199E,115 NXP Semiconductors, KMA199E,115 Datasheet - Page 26
![IC SENSOR PROG ANGLE SOT880](/photos/27/2/270220/kma199e_sml.jpg)
KMA199E,115
Manufacturer Part Number
KMA199E,115
Description
IC SENSOR PROG ANGLE SOT880
Manufacturer
NXP Semiconductors
Datasheet
1.KMA199E115.pdf
(31 pages)
Specifications of KMA199E,115
Position - Sensing
180°
Sensor Type
Angular - Magnetoresistive
Voltage - Supply
4.5 V ~ 5.5 V
Operating Temperature
-40°C ~ 160°C
Supply Current
10 mA
Maximum Operating Temperature
+ 160 C
Minimum Operating Temperature
- 40 C
Supply Voltage (max)
5.5 V
Supply Voltage (min)
4.5 V
Package / Case
SOT-880
Output Type
Analog - Voltage
Operating Temperature (min)
-40C
Operating Supply Voltage (typ)
5V
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Lead Free Status / RoHS Status
Lead free / RoHS Compliant, Lead free / RoHS Compliant
Other names
568-4329-2
934061291115
KMA199E T/R
KMA199E T/R
934061291115
KMA199E T/R
KMA199E T/R
NXP Semiconductors
15. ElectroStatic Discharge (ESD)
16. Application information
KMA199E_1
Product data sheet
15.1 Human body model
15.2 Machine model
Test time: 10 min.
Transient transmission by capacitive and inductive coupling via lines other than supply
lines (interface, analog output) have to be tolerated according to ISO 7637-3 (pulses 3a
and 3b).
To raise immunity against ESD pulses, protection diodes are implemented into the
KMA199E.
The KMA199E must not be damaged at 8 kV, according to the human body model at
100 pF and 1.5 k . The test is according to AEC-Q100, Rev-E, method 002. This
protection must be ensured at all external pins (OUT/DIGINT, V
Furthermore all interconnects (pins between package head and package body) must not
be damaged at 2 kV, according to AEC-Q100, Rev-E, method 002.
The KMA199E must not be damaged at 400 V, according to the machine model. The test
is according to AEC-Q100, Rev-E, method 003. This protection must be ensured at all
external pins (OUT/DIGINT, V
Furthermore all interconnects (pins between package head and package body) must not
be damaged at 200 V, according to AEC-Q100, Rev-E, method 003.
All pins have a latch-up protection.
Fig 16. Application diagram of KMA199E
(1) The block capacitance C
best functionality, the capacitances should be mounted close to the pins of the device.
C block
KMA199E and external
Rev. 01 — 18 October 2007
KMA199E
capacitances
1
2
V
GND
DD
block
DD
3
is used to suppress noise on the supply line of the device. For
OUT/DIGINT
and GND).
C L
pull-down to GND
pull-up to V
electronic control unit
DD
f
g
1
or
FILTER
= 0.7 kHz
st
order
Programmable angle sensor
DD
V
OUT/DIGINT
GND
and GND).
DD
KMA199E
001aag820
© NXP B.V. 2007. All rights reserved.
26 of 31