BK2534 B&K Precision, BK2534 Datasheet - Page 6

• Manufacturer Part Number: BK2534
• Description: OSCOPE 60MHZ DIGITAL STORAGE
• Manufacturer: B&K Precision
• Type: Bench, Digitalr

Specifications of BK2534

• Includes: Probes, Software, USB Cable
• Bandwidth: 60MHz
• Channels: Dual
• Display Type: LCD - Color
• Features: Software Controllable, USB Port, Waveform Capture
• Probe Type: PR-37A x1/x10/Ref Probes (2)
• Sampling Rate (per Second): 400MSa/s
• Input Impedance: 1M - 19pF
• Rise Time (typ): 5.83nS
• Voltage - Input, Max: 400Vpeak
• Voltage - Supply: 100 ~ 240VAC
• Lead Free Status / RoHS Status: Not applicable / Not applicable

7.
Press the RUN/STOP key again to stop acquiring data.
The RUN/STOP key will be red. Now you may examine
the acquired waveform by panning and zooming.
Press the SINGLE key to acquire a single waveform
trace. The key will remain orange until the oscilloscope is
triggered.
displayed and triggering is disabled until re-armed by
pressing the SINGLE key again.
Vertical controls
You can use the vertical position control knob to move
the waveforms up or down on the display. There is one
vertical position control knob for each channel.
You can press the channel key CH1 or CH2 to switch the
channel on or off or access the associated channel menu
via the softkeys. There is one channel on/off key for each
channel.
You can press the MATH key to access the FFT (Fast
Fourier Transform), multiply, subtract, and add functions.
You can press the REF key to save or load a reference
waveform from the internal memory or an external USB
mass storage device.
You can use the vertical scale control knob to change the
vertical scale of a waveform. The waveform display will
After the trigger event, the waveform is
Getting Started
11
12
Getting Started
8.
9.
10. Probe compensation terminals
Horizontal controls
Trigger controls
contract or expand relative to the ground reference level.
There is one vertical scale control knob for each channel.
When the oscilloscope is in run mode, the horizontal
position control knob lets you set the acquisition window
relative to the trigger point. When acquisition is stopped,
you can turn this knob to pan through the stored
waveform data horizontally. This lets you see the
captured waveform before or after the trigger.
Press the horizontal MENU key to access the menu
where you can activate a delayed sweep or select X-Y or
Roll modes.
Turn the horizontal sweep rate control knob to adjust the
sweep speed. This changes the time base on the
display. When adjusted after the waveform has been
acquired and the oscilloscope is stopped, this has the
effect of stretching or compressing the waveform
horizontally.
These controls are used to control how the oscilloscope
triggers to capture waveforms.