NT31C-ST143-EV3 Omron, NT31C-ST143-EV3 Datasheet - Page 151

• Manufacturer Part Number: NT31C-ST143-EV3
• Description: 5.7 8-Color Dsp,STN,Ivory,Eng
• Manufacturer: Omron

Specifications of NT31C-ST143-EV3

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Starting the NT31/NT31C
Memory Unit Check and
Processing
Start of Communications
with the Host
Operation Start
134
Check if a Memory Unit is installed. If a Memory Unit is installed, processing
(screen data and system program reading/writing) is executed in accordance
with its DIP switch settings (page 36).
If there is an error in the screen data, an error screen is displayed. Pressing
the OK touch switch on the error screen will return the display to that immedi-
ately before the error occurred. It is also possible to display the System Menu
from the error screen by pressing two of the four corners of the touch panel
simultaneously. If there is an error in the system program, the main menu of
the system installer mode is displayed. If this is the case, reinstall the proper
system program.
Initialize the memory or change the settings as required.
Communications with the host starts in accordance with the communications
method set in the system memory of the NT31/NT31C. During the interval
until communications are established, the system initialization screen (screen
No. 9000) is displayed.
For details, refer to 6-8 Starting Operation.
If the system initialization screen remains on, display the System Menu by
pressing two of the four corners of the touch panel simultaneously, and check
the settings for the communications conditions for communications with the
host.
The RUN mode is established, and operation starts in accordance with the
screen data in the NT31/NT31C.
When changing the settings or checking the statuses, perform the appropriate
operation by displaying the System Menu. For details on displaying the Sys-
tem Menu, refer to 6-3-3 Operations with the System Menu (page 138).
Section 6-2