74LVC125APW-T NXP Semiconductors, 74LVC125APW-T Datasheet - Page 16

no-image

74LVC125APW-T

Manufacturer Part Number
74LVC125APW-T
Description
Buffer/Line Driver 4-CH Non-Inverting 3-ST CMOS 14-Pin TSSOP T/R
Manufacturer
NXP Semiconductors
Datasheet

Specifications of 74LVC125APW-T

Package
14TSSOP
Logic Family
LVC
Logic Function
Buffer/Line Driver
Number Of Outputs Per Chip
4
Output Type
3-State
Input Signal Type
Single-Ended
Maximum Propagation Delay Time @ Maximum Cl
2.4(Typ)@3.3V ns
Tolerant I/os
5 V
Typical Quiescent Current
0.1 uA
Polarity
Non-Inverting
Philips Semiconductors
Suitability of surface mount IC packages for wave and reflow soldering methods
Notes
1. For more detailed information on the BGA packages refer to the “(LF)BGA Application Note ” (AN01026); order a copy
2. All surface mount (SMD) packages are moisture sensitive. Depending upon the moisture content, the maximum
3. These packages are not suitable for wave soldering. On versions with the heatsink on the bottom side, the solder
4. If wave soldering is considered, then the package must be placed at a 45 angle to the solder wave direction.
5. Wave soldering is suitable for LQFP, TQFP and QFP packages with a pitch (e) larger than 0.8 mm; it is definitely not
6. Wave soldering is suitable for SSOP, TSSOP, VSO and VSSOP packages with a pitch (e) equal to or larger than
2003 May 07
BGA, LBGA, LFBGA, SQFP, TFBGA, VFBGA
DHVQFN, HBCC, HBGA, HLQFP, HSQFP, HSOP, HTQFP,
HTSSOP, HVQFN, HVSON, SMS
PLCC
LQFP, QFP, TQFP
SSOP, TSSOP, VSO, VSSOP
Quad buffer/line driver with 5 V tolerant input/outputs;
3-state
from your Philips Semiconductors sales office.
temperature (with respect to time) and body size of the package, there is a risk that internal or external package
cracks may occur due to vaporization of the moisture in them (the so called popcorn effect). For details, refer to the
Drypack information in the “Data Handbook IC26; Integrated Circuit Packages; Section: Packing Methods” .
cannot penetrate between the printed-circuit board and the heatsink. On versions with the heatsink on the top side,
the solder might be deposited on the heatsink surface.
The package footprint must incorporate solder thieves downstream and at the side corners.
suitable for packages with a pitch (e) equal to or smaller than 0.65 mm.
0.65 mm; it is definitely not suitable for packages with a pitch (e) equal to or smaller than 0.5 mm.
(4)
, SO, SOJ
PACKAGE
(1)
16
not suitable
not suitable
suitable
not recommended
not recommended
WAVE
(3)
SOLDERING METHOD
(4)(5)
(6)
suitable
suitable
suitable
suitable
suitable
Product specification
74LVC125A
REFLOW
(2)

Related parts for 74LVC125APW-T