ISP1505ABS-S NXP Semiconductors, ISP1505ABS-S Datasheet - Page 11
![no-image](/images/manufacturer_photos/0/4/487/nxp_semiconductors_sml.jpg)
ISP1505ABS-S
Manufacturer Part Number
ISP1505ABS-S
Description
Manufacturer
NXP Semiconductors
Datasheet
1.ISP1505ABS-S.pdf
(76 pages)
Specifications of ISP1505ABS-S
Number Of Transceivers
1
Esd Protection
YeskV
Operating Supply Voltage (typ)
Not RequiredV
Operating Temperature Classification
Industrial
Operating Supply Voltage (max)
Not RequiredV
Operating Supply Voltage (min)
Not RequiredV
Mounting
Surface Mount
Operating Temperature (max)
85C
Operating Temperature (min)
-40C
Lead Free Status / RoHS Status
Compliant
NXP Semiconductors
ISP1505A_ISP1505C_3
Product data sheet
7.10.6.1 V
7.10.6.2 FAULT (external overcurrent or fault detector)
7.10.2 V
7.10.3 RREF
7.10.4 DP and DM
7.10.5 V
7.10.6 V
The input power pin that sets the I/O voltage level. For details, see
and
Resistor reference analog I/O pin. A resistor, R
and GND, as shown in
biases internal analog circuitry. Less accurate resistors cannot be used and will render the
ISP1505 unusable.
The DP (data plus) and DM (data minus) are USB differential data pins. These must be
connected to the D+ and D pins of the USB receptacle.
V
recommended. For details, see
This pin provides two options for V
this pin must be connected to ground.
By default, this pin acts as an input to V
discharges V
The V
To prevent electrical overstress, it is strongly recommended that you attach a series
resistor on the V
internal charge pump. For details, see
If an external V
circuit can be connected to the ISP1505 FAULT input pin. The ISP1505 will inform the link
of V
must:
•
•
•
•
•
•
CC
BUS
•
•
•
CC(I/O)
CC
BUS
CLOCK
DATA[7:0]
DIR
NXT
RESET_N
STP
BUS
Set the USE_EXT_VBUS_IND register bit to logic 1.
Set the polarity of the external fault signal using the IND_COMPL register bit.
Set the IND_PASSTHRU register bit to logic 1.
Section
is the main input supply voltage for the ISP1505. Decoupling capacitors are
/FAULT
BUS
fault events by sending RXCMDs on the ULPI bus. To use the FAULT pin, the link
pin requires a capacitive load as shown in
16. V
BUS
BUS
BUS
for SRP.
CC(I/O)
overcurrent or fault circuit is used, the output fault indicator of that
pin (R
Rev. 03 — 26 August 2008
Section
provides power to on-chip pads of the following pins:
VBUS
16. This provides an accurate voltage reference that
). R
Section
BUS
VBUS
Section
driving and monitoring. If neither function is used,
BUS
16.
must not be attached when using the ISP1505
ULPI HS USB host and peripheral transceiver
comparators, and also charges and
ISP1505A; ISP1505C
RREF
16.
, must be connected between RREF
Section
16.
Section
© NXP B.V. 2008. All rights reserved.
12,
Section 13
10 of 75