MC34910G5ACR2 Freescale, MC34910G5ACR2 Datasheet - Page 73
![](/photos/31/26/312678/296-32-tqfp_sml.jpg)
MC34910G5ACR2
Manufacturer Part Number
MC34910G5ACR2
Description
Manufacturer
Freescale
Datasheet
1.MC34910G5ACR2.pdf
(90 pages)
Specifications of MC34910G5ACR2
Turn Off Delay Time
10us
Number Of Drivers
2
Operating Temperature (min)
-40C
Lead Free Status / RoHS Status
Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
MC34910G5ACR2
Manufacturer:
Freescale Semiconductor
Quantity:
10 000
WINDOW WATCHDOG
which is active in Normal mode. The watchdog can be
configured by an external resistor connected to the WDCONF
pin. The resistor is used to achieve higher precision in the
timebase used for the watchdog.
MOD bits of the MCR.
not allowed; but after the first half of the PSPI-timeout window
the clear operation opens. If a clear operation is performed
outside the window, the 33910 will reset the MCU, in the
same way as when the watchdog overflows.
must connect the WDCONF pin to ground. This measure
effectively disables Normal Request mode. The WDOFF bit
73
33910
FUNCTIONAL DEVICE OPERATIONS
OPERATIONAL MODES
The 33910 includes a configurable window watchdog
SPI clears are performed by writing through the SPI in the
During the first half of the SPI timeout watchdog clears are
To disable the watchdog function in Normal mode the user
WD TIMING X 50%
NO WATCHDOG CLEAR
Figure 37. Window Watchdog Operation
WINDOW CLOSED
WD TIMING SELECTED BY REGISTER
ALLOWED
ON WDCONF PIN
WD PERIOD (t
PWD
WD TIMING X 50%
FOR WATCHDOG
WINDOW OPEN
)
CLEAR
in the WDSR will be set. This condition is only detected
during Reset mode.
the watchdog falls back to the internal lower precision
timebase of 150 ms (typ.) and signals the faulty condition
through the WDSR.
prescaler which can be configured by the TIMCR. During
Normal Request mode, the window watchdog is not active
but there is a 150 ms (typ.) timeout for leaving the Normal
Request mode. In case of a timeout, the 33910 will enter into
Reset mode, resetting the microcontroller before entering
again into Normal Request mode.
HIGH SIDE OUTPUT PINS HS1 AND HS2
small resistive loads or LEDs incorporating the following
features:
the High Side Control Register (HSCR).
PWM Capability (direct access)
direct control via the PWMIN pin.
Control Register (HSCR), then the HS1 driver is turned on if
the PWMIN pin is high and turned of if the PWMIN pin is low.
This applies to HS2 configuring HS2 and PWMHS2 bits.
If neither a resistor nor a connection to ground is detected,
The watchdog timebase can be further divided by a
These outputs are two high side drivers intended to drive
• PWM capability (software maskable)
• Open load detection
• Current limitation
• Over-temperature shutdown (with maskable interrupt)
• High-voltage shutdown (software maskable)
• Cyclic sense
The high side switches are controlled by the bits HS1:2 in
Each high side driver offers additional (to the SPI control)
If both the bits HS1 and PWMHS1 are set in the High Side
Analog Integrated Circuit Device Data
Freescale Semiconductor