ICS9DB801CGLF IDT, Integrated Device Technology Inc, ICS9DB801CGLF Datasheet - Page 14

• Manufacturer Part Number: ICS9DB801CGLF
• Description: IC BUFFER 8OUTPUT DIFF 48-TSSOP
• Manufacturer: IDT, Integrated Device Technology Inc
• Type: Clock Bufferr
• Series: -r

Specifications of ICS9DB801CGLF

• Input: Clock
• Output: Clock
• Frequency - Max: 400MHz
• Voltage - Supply: 3.135 V ~ 3.465 V
• Operating Temperature: 0°C ~ 70°C
• Mounting Type: Surface Mount
• Package / Case: 48-TSSOP
• Frequency-max: 400MHz
• Number Of Elements: 1
• Supply Current: 200mA
• Pll Input Freq (min): 50MHz
• Pll Input Freq (max): 200MHz
• Operating Supply Voltage (typ): 3.3V
• Operating Temp Range: 0C to 70C
• Package Type: TSSOP
• Output Frequency Range: 50 to 200MHz
• Operating Supply Voltage (min): 3.135V
• Operating Supply Voltage (max): 3.465V
• Operating Temperature Classification: Commercial
• Pin Count: 48
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 9DB801CGLF

Note: Polarities in timing diagrams are shown OE_INV = 0. They are similar to OE_INV = 1.
PD#, Power Down
The PD# pin cleanly shuts off all clocks and places the device into a power saving mode. PD# must be asserted before shutting
off the input clock or power to insure an orderly shutdown. PD is asynchronous active-low input for both powering down the
device and powering up the device. When PD# is asserted, all clocks will be driven high, or tri-stated (depending on the PD#
drive mode and Output control bits) before the PLL is shut down.
PD# Assertion
When PD# is sampled low by two consecutive rising edges of DIF#, all DIF outputs must be held High, or tri-stated (depending
on the PD# drive mode and Output control bits) on the next High-Low transition of the DIF# outputs. When the PD# drive mode
bit is set to ‘0’, all clock outputs will be held with DIF driven High with 2 x I
set to ‘1’, both DIF and DIF# are tri-stated.
PD# De-assertion
Power-up latency is less than 1 ms. This is the time from de-assertion of the PD# pin, or VDD reaching 3.3V, or the time from
valid SRC_IN clocks until the time that stable clocks are output from the device (PLL Locked). If the PD# drive mode bit is set
to ‘1’, all the DIF outputs must driven to a voltage of >200 mV within 300 us of PD# de-assertion.
IDT
ICS9DB801C
Eight Output Differential Buffer for PCI Express (50-200MHz)
TM
/ICS
TM
Eight Output Differential Buffer for PCI Express (50-200MHz)
PWRDWN#
PWRDWN#
DIF#
DIF#
DIF
DIF
Tstable
<1mS
<300uS, >200mV
Tdrive_PwrDwn#
14
REF
and DIF# tri-stated. If the PD# drive mode bit is
9DB801C
REV E 01/27/11