MK3805RILFTR IDT, Integrated Device Technology Inc, MK3805RILFTR Datasheet - Page 3

• Manufacturer Part Number: MK3805RILFTR
• Description: IC BUFFER/CLOCK DRIVER 20-QSOP
• Manufacturer: IDT, Integrated Device Technology Inc
• Type: Fanout Buffer (Distribution)r

Specifications of MK3805RILFTR

• Number Of Circuits: 2
• Ratio - Input:output: 1:5
• Differential - Input:output: No/No
• Input: LVCMOS
• Output: LVCMOS
• Frequency - Max: 100MHz
• Voltage - Supply: 3.13 V ~ 3.46 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 20-QSOP
• Frequency-max: 100MHz
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

External Components
The MK3805 requires a minimum number of external
components for proper operation.
Decoupling Capacitors
Decoupling capacitors of 0.01µF must be connected
between VDD and GND, as close to these pins as possible.
For optimum device performance, the decoupling capacitors
should be mounted on the component side of the PCB.
Avoid the use of vias in the decoupling circuit.
Series Termination Resistor
When the PCB trace between the clock outputs and the
loads are over 1 inch, series termination should be used. To
series terminate a 50 trace (a commonly used trace
impedance) place a 33 resistor in series with the clock line,
as close to the clock output pin as possible. The nominal
impedance of the clock output is 20 .
Absolute Maximum Ratings
IDT™ BUFFER/CLOCK DRIVER
MK3805
BUFFER/CLOCK DRIVER
Stresses above the ratings listed below can cause permanent damage to the MK3805. These ratings, which are
standard values for IDT commercially rated parts, are stress ratings only. Functional operation of the device at these
or any other conditions above those indicated in the operational sections of the specifications is not implied.
Exposure to absolute maximum rating conditions for extended periods can affect product reliability. Electrical
parameters are guaranteed only over the recommended operating temperature range.
Supply Voltage, VDD
All Inputs and Outputs
Ambient Operating Temperature
Storage Temperature
Junction Temperature
Soldering Temperature
Item
3
PCB Layout Recommendations
For optimum device performance and lowest output phase
noise, the following guidelines should be observed.
1) The 0.01µF decoupling capacitors should be mounted on
the component side of the board as close to the VDD pins
as possible. No vias should be used between the
decoupling capacitors and VDD pins. The PCB trace to VDD
pin should be kept as short as possible, as should the PCB
trace to the ground via.
2) To minimize EMI, the 33 series termination resistor (if
needed) should be placed close to the clock output.
3) An optimum layout is one with all components on the
same side of the board, minimizing vias through the signal
layers. Other signal traces should be routed away from the
MK3805. This includes signal traces just underneath the
device, or on layers adjacent to the ground plane layer used
by the device.
7 V
-0.5 V to VDD+0.5 V
-40 to +85 C
-65 to +150 C
125 C
260 C
Rating
MK3805
FAN OUT BUFFER
REV E 051310