ISP1564HLUM STEricsson, ISP1564HLUM Datasheet - Page 38
![](/photos/31/30/313030/406-100-lqfp_sml.jpg)
ISP1564HLUM
Manufacturer Part Number
ISP1564HLUM
Description
Manufacturer
STEricsson
Datasheet
1.ISP1564HLUM.pdf
(100 pages)
Specifications of ISP1564HLUM
Operating Supply Voltage (typ)
3.3V
Operating Supply Voltage (min)
3V
Operating Supply Voltage (max)
3.6V
Operating Temp Range
-40C to 85C
Operating Temperature Classification
Industrial
Mounting
Surface Mount
Pin Count
100
Lead Free Status / Rohs Status
Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
NXP Semiconductors
Table 52.
Address: Content of the base address register + 04h
ISP1564_1
Product data sheet
Bit
31 to 11
10
9
8
7 to 6
5
Symbol
reserved
RWE
RWC
IR
HCFS
[1:0]
BLE
HcControl - Host Controller Control register bit description
Description
-
Remote Wake-up Enable: This bit is used by the HCD to enable or disable the remote wake-up
feature on detecting upstream resume signaling. When this bit and RD (bit 3) in the
HcInterruptStatus register are set, a remote wake-up is signaled to the host system. Setting this bit
has no impact on the generation of hardware interrupt.
Remote Wake-up Connected: This bit indicates whether the Host Controller supports remote
wake-up signaling. If remote wake-up is supported and used by the system, it is the responsibility of
the system firmware to set this bit during POST. The Host Controller clears the bit on a hardware
reset but does not alter it on a software reset. Remote wake-up signaling of the host system is
host-bus-specific and is not described in this specification.
Interrupt Routing: This bit determines the routing of interrupts generated by events registered in
HcInterruptStatus. If clear, all interrupts are routed to the normal host bus interrupt mechanism. If
set, interrupts are routed to the system management interrupt. The HCD clears this bit on a
hardware reset, but it does not alter this bit on a software reset. The HCD uses this bit as a tag to
indicate the ownership of the Host Controller.
Host Controller Functional State for USB:
00b — USBRESET
01b — USBRESUME
10b — USBOPERATIONAL
11b — USBSUSPEND
A transition to USBOPERATIONAL from another state causes SOF generation to begin 1 ms later.
The HCD may determine whether the Host Controller has begun sending SOFs by reading SF
(bit 2) in HcInterruptStatus.
This field may be changed by the Host Controller only when in the USBSUSPEND state. The Host
Controller may move from the USBSUSPEND state to the USBRESUME state after detecting the
resume signaling from a downstream port.
The Host Controller enters USBSUSPEND after a software reset; it enters USBRESET after a
hardware reset. The latter also resets the root hub and asserts subsequent reset signaling to
downstream ports.
Bulk List Enable: This bit is set to enable the processing of the bulk list in the next frame. If cleared
by the HCD, processing of the bulk list does not occur after the next SOF. The Host Controller
checks this bit whenever it wants to process the list. When disabled, the HCD may modify the list. If
HcBulkCurrentED is pointing to an Endpoint Descriptor (ED) to be removed, the HCD must advance
the pointer by updating HcBulkCurrentED before re-enabling processing of the list.
Rev. 01 — 4 December 2006
HS USB PCI Host Controller
© NXP B.V. 2006. All rights reserved.
ISP1564
37 of 99