VQ1101N-51 SMC Corporation, VQ1101N-51 Datasheet - Page 74

• Manufacturer Part Number: VQ1101N-51
• Description: VALVE; SOLENOID; 6 MM; 15 W (MAX.); 24 VDC; 2 POSITION SINGLE; METAL; 0.5 MPA
• Manufacturer: SMC Corporation
• Type: Solenoidr

Specifications of VQ1101N-51

• Brand/series: VQ Series
• Configuration: 2-Position Single
• Enclosure Rating: IP65
• Fluid Type: Air/Inert Gas
• Pressure, Operating: 0.7 MPa
• Primary Type: Solenoid Valve
• Temperature, Ambient: –10° to +50°C
• Valve Type: 5-Port Solenoid, Plug-In, Base Mounted with 2 Position Actuation, Rubber Seal, Negative Common
• Voltage, Coil: 24 VDC

Series
This silencer is to be inserted into the EXH port (One-
touch fittings).
VQ2000: Manifold Optional Parts
DIN rail mounting bracket [-D/-D0/-D„]
VVQ2000-57A
It is used for mounting a manifold on a DIN rail.
1 set of DIN rail mounting bracket is used for 1 manifold
(2 DIN rail mounting brackets).
Direct EXH outlet with built-in silencer [-S]
This is a type with an exhaust port atop the manifold
end plate. The built-in silencer exhibits an excellent
noise suppression effect. (Noise reduction: 30 dB)
Silencer (For EXH port)
Elbow fitting assembly
VVQ2000-F-L(C4/C6/C8/N3/N7/N9)
It is used for piping that extends upward or downward
from the manifold.
When not installed in the manifold stations, specify the
assembly part number and the mounting position by
means of the manifold specification sheet.
Dual flow fitting assembly
VVQ2000-52A-
This is a fitting to multiply the flow rate by combining
the outputs of 2-valve stations. It is used for driving a
large bore cylinder. This is a one-touch fitting for a port
size of ø10 or ø3/8".
73
fold, suffix “-D” to the end of the manifold part num-
ber.
fold, suffix “-S” to the end of the manifold part num-
ber.
When ordering this option incorporated with a mani-
When ordering this option incorporated with a mani-
Note) A large quantity of drainage generated in the
b Refer to back page 5 for maintenance.
air source results in exhaust of air together
with drainage.
VQ2000
C10
N11
The port size for the manifold part number is “CM”.
Clearly indicate the dual flow fitting assembly part number and specify the mounting position by
means of the manifold specifications.
DIN rail clamp screw
Exhaust
Dimensions
VQ2000
Series
Applicable
fitting size
ø
10
d
AN200-KM10
Model
59.6 80.8
A
L
22
D
area (mm
(Cv factor)
Effective
26 (1.4)
2
)
reduction
Noise
(dB)
30