ES-TN-1H5 BANNER ENGINEERING, ES-TN-1H5 Datasheet - Page 16

• Manufacturer Part Number: ES-TN-1H5
• Description: MODULE; SAFETY; E-STOP GUARD; MONITORING MODULE
• Manufacturer: BANNER ENGINEERING

Specifications of ES-TN-1H5

• Coil Voltage Vdc Nom: 24V
• Contact Current Max: 4A
• Contact Voltage Ac Nom: 250V
• Contact Voltage Dc Nom: 250V
• Contact Configuration: SPST-NC
• No. Of Poles: 1
• Relay Mounting: DIN Rail
• External Height: 85.5mm

NOTE: Do not attempt any repairs to the ES-TN-1H5 or 1H6 Emergency Stop Safety
If it ever becomes necessary to return an E-Stop Safety Module to the factory, please
do the following:
E-Stop Safety Modules with Adjustable Delay
Figure 8. E-Stop Safety Modules ES-TN-1H5 and ES-TN-1H6 enclosure dimensions
P/N 58697 Rev. A
P/N 63443 rev A.
1) Contact the Banner Factory Application Engineering Group at the address or at
2) Pack the E-Stop Safety Module carefully. Damage which occurs in return shipping
Banner Engineering Corp., 9714 Tenth Ave. No., Minneapolis, MN 55441 • Phone: [phone] • www.bannerengineering.com • Email: [e-mail]
the numbers listed below. They will attempt to troubleshoot the system from your
description of the problem. If they conclude that a component is defective, they
will issue an RMA (Return Merchandise Authorization) number for your paperwork,
and give you the proper shipping address.
is not covered by warranty.
Module. It contains no field-replaceable components. Return the Safety
Module to the factory for warranty repair or replacement.
119.0 mm
(4.69")
Repairs
WARRANTY: Banner Engineering Corp. warrants its products to be free from defects
for one year. Banner Engineering Corp. will repair or replace, free of charge, any product
of its manufacture found to be defective at the time it is returned to the factory during
the warranty period. This warranty does not cover damage or liability for the improper
application of Banner products. This warranty is in lieu of any other warranty either
expressed or implied.
85.5 mm
(3.35")
44.1 mm
(1.74")
— Models ES-TN-1H5/-1H6
occurred and the Module will not reset,
do not tap, strike, or otherwise attempt
to correct the fault by a physical impact
to the housing. An internal relay may
have failed in such a manner that its
replacement is required.
If the Module is not immediately
replaced or repaired, multiple
simultaneous failures may accumulate
such that the safety function can not be
guaranteed.
!
WARNING . . .
Abuse of Module After
Failure
If an internal fault has