804-1210 XANTREX TECHNOLOGY, 804-1210 Datasheet - Page 42

• Manufacturer Part Number: 804-1210
• Description: BATTERY CHARGER, LEAD ACID, 265VAC
• Manufacturer: XANTREX TECHNOLOGY

Specifications of 804-1210

• Battery Charger Type: Switch Mode
• Battery Technologies Supported: Lead Acid
• Supply Voltage: 265VAC

Installation
2–18
This guide for use by qualified installers only
7. Connect the negative cable to the negative DC terminal.
For one battery or bank
◆ Connect the negative cable from the negative terminal on
For more than one battery or bank
◆ Connect the negative cable from the negative terminal on
8. Tighten the nuts to 2.3 N-m (20 lb-in.) torque and test
9. Connect each positive cable to the correct positive DC
10. Tighten the nuts to 2.3 N-m (20 lb-in.) torque and test
11. Connect the free end of each positive cable assembly to
12. Connect the free end of the negative cable to the negative
See Figure 2-1, “Typical Truecharge™ 2 Battery Charger
System Installation” on page 2–3.
the battery to the negative DC terminal on the
Truecharge™ 2 Battery Charger.
Use a flat washer, a lock washer and a nut (five included
in the installation kit) to secure the connection.
the negative ground bar or bus to the negative DC
terminal on the Truecharge™ 2 Battery Charger.
Use a flat washer, a lock washer and a nut (five included
in the installation kit) to secure the connection.
that the wire is secure. Do not over-tighten as this may
result in damage to the charger.
terminal on the Truecharge™ 2 Battery Charger.
Use a flat washer, a lock washer and a nut (5 included in
the installation kit) to secure the connection.
that the wire is secure.
the correct positive terminal of the battery, using
sufficient torque as recommended by your battery
manufacturer.
terminal on the battery, using sufficient torque as
recommended by your battery manufacturer.
NOTE: If you are using more than one battery, you will
need to connect the negative cable from each of the
batteries to the negative ground bar or bus. The negative
ground bar or bus will then have a single negative cable
connecting to the negative charger terminal.
975-0402-01-01