804-1210 XANTREX TECHNOLOGY, 804-1210 Datasheet - Page 46

• Manufacturer Part Number: 804-1210
• Description: BATTERY CHARGER, LEAD ACID, 265VAC
• Manufacturer: XANTREX TECHNOLOGY

Specifications of 804-1210

• Battery Charger Type: Switch Mode
• Battery Technologies Supported: Lead Acid
• Supply Voltage: 265VAC

Installation
2–22
To connect AC wires with the provided crimp-on butt-splice
connector:
1.Provided butt-splice connector (catalog number BNYF2) is available from
www.ksterminals.com.
2.Use crimper (product number CT-160) from www.panduit.com.
This guide for use by qualified installers only
WARNING: Fire hazard
Improper connections may overheat. Exercise care when using any
crimp connector, use the tool specified by the crimp connector
manufacturer, and follow all instructions.
STRIP 5/16”
a) Make the connections using the provided crimp-on
b) Using a wire stripper, carefully strip 8 mm (5/16 in.)
c) Insert one wire into one end of the butt-splice, until
d) Repeat Step c for the other end of the butt-splice.
connectors
required by your code, and suitable for your
installation.
For example, the ABYC Standards and
Recommended Practices for Small Craft prohibit
twist-on connectors for AC connections on a boat.
For other types of installation, refer to your
applicable code.
from the ends of the two wires being connected.
the insulation hits the internal metal crimp section,
insert the butt-splice into the crimper
firmly. The proper location for the crimp is
approximately 1.6 mm (1/16 in.) past where the butt-
splice insulation tapers down as shown.
1
or with other approved connectors
1/16 “
CRIMP TOOL
2
975-0402-01-01
, and crimp