804-1210 XANTREX TECHNOLOGY, 804-1210 Datasheet - Page 44

• Manufacturer Part Number: 804-1210
• Description: BATTERY CHARGER, LEAD ACID, 265VAC
• Manufacturer: XANTREX TECHNOLOGY

Specifications of 804-1210

• Battery Charger Type: Switch Mode
• Battery Technologies Supported: Lead Acid
• Supply Voltage: 265VAC

Installation
Installing AC Wiring
2–20
AC wiring access hole
This guide for use by qualified installers only
Before connecting AC wiring, make sure the AC source
circuit is protected by a breaker switch of the correct size and
type, to comply with the electrical code for your location and
application. The current rating of the input breaker should not
be larger than 20 A for 120 Vac applications and 16 A for
230 Vac applications, but may be required to be lower
depending on the wire size used.
WARNING: Shock hazard
Disconnect the AC source by turning off the breaker feeding the
circuit, unplugging from shore power and disconnecting any other
power sources (such as a generator).
1. Plan the route that the AC supply wiring will follow from
2. Measure and cut the required length of three-conductor
3. Route the AC supply wiring from the charger (in its
4. Unscrew the wiring compartment cover from the left rear
the source (usually an AC distribution panel) to the
Truecharge™ 2 Battery Charger.
(L, N,
connections and providing some slack.
mounted position) to the source.
of the Truecharge™ 2 Battery Charger to expose the AC
wiring access hole and charger’s AC pigtail leads.
GND
) cable allowing some extra length for
wiring compartment
cover
AC pigtail leads
975-0402-01-01