3F88L-CG001N Omron, 3F88L-CG001N Datasheet - Page 143
![no-image](/images/manufacturer_photos/0/4/494/omron_sml.jpg)
3F88L-CG001N
Manufacturer Part Number
3F88L-CG001N
Description
CABLE CAM OUTPUT-I/O BLOCK 1M
Manufacturer
Omron
Datasheet
1.3F88L-RL10.pdf
(232 pages)
Specifications of 3F88L-CG001N
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
3F88LCG001N
- Current page: 143 of 232
- Download datasheet (5Mb)
Operation
Operation
D Slave Cam Positioner Settings
• Use the Bank/Function Key to set data transfer (Function No. t) and press the Set Key. “0” (Slave Unit
• The settings for the Slave Unit have now been completed. While this data is displayed, make the set-
D Master Cam Positioner Settings
• Use the Bank/Function Key to set data transfer (Function No. t) and press the Set Key. “0” (Slave Unit
• Press the Cam/Parameter Key to display “1” (Master Unit settings)
• ”0” will flash in the SPEED/ON display.
• Use the Up and Down Keys to set the data.
• If the incorrect setting is made, e.g., if data read (setting “1”) and data write (setting “2”) settings are
• Press the Set Key to start communications with the Slave Cam Positioner Unit. During the transfer, the
Note 1. The data being transferred will be displayed on the Master Unit only.
Note 2. The display will not include “b5” to “b8” for 720 resolution.
• When the communications have been completed normally, press the Set Key to return to the previous
• If a communications error has occurred, the error code will appear in the SPEED/ON display. Check
Additional Information on the Copy Function
settings) will appear in the Cam/Parameter No. display.
tings for the Master Cam Positioner Unit.
settings) will appear in the Cam/Parameter No. display.
mistaken, important data may be deleted. Check again that the correct setting has been selected.
data being transferred (P: parameter; b1 to b8: bank numbers 1 to 8) will be appear in the POSITION/
OFF display. The communications will take approximately 40 seconds to be completed.
display.
the error and press the Clear Key. The error will be cleared. Press the Set Key to return to the previous
display.
0: Disabled (factory setting)
1: Data read (Reads cam programs and parameters from the Slave to the Master Unit.)
2: Data write (Writes cam programs and parameters from the Master to the Slave Unit.)
3: Data verification (Verifies the Master programs and parameters against the Slave programs and
parameters.)
S S S S Data Transferred
All cam programs and parameters will be transferred from one Cam Positioner Unit to the other.
The contents of Function No. t (data transfer) and Function No. P (pulse output setting) will not be
transferred.
Data transfer
Data transfer (Slave Unit settings)
Data transfer (Master Unit settings)
Chapter 3
3-91