ZPM3570-E RFM, ZPM3570-E Datasheet - Page 16

no-image

ZPM3570-E

Manufacturer Part Number
ZPM3570-E
Description
TXRX ZIGBEE PRO MODULE
Manufacturer
RFM
Series
ZPMr
Datasheet

Specifications of ZPM3570-E

Frequency
2.4GHz ~ 2.5GHz
Data Rate - Maximum
-
Modulation Or Protocol
802.15.4 Zigbee
Applications
General Purpose
Power - Output
20dBm
Sensitivity
-103dBm
Voltage - Supply
2.4 V ~ 3.4 V
Current - Receiving
35mA
Current - Transmitting
175mA
Data Interface
Solder Pad
Memory Size
8Mbits
Antenna Connector
On-Board, Chip
Operating Temperature
-40°C ~ 85°C
Package / Case
Module
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
583-1162
9 Ordering Information
Module: ZPM3570
Development Kit: ZPM3570DK
10 RoHS Declaration
Given supplier declarations, this product does not contain substances that are banned by Directive
2002/95/EC or contains a maximum concentration of 0.1% by weight in homogeneous materials for
And a maximum concentration of 0.01% by weight in homogeneous materials for
11 Regulatory Information
ZPM3750 has obtained the certifications described below.
11.1 FCC Notice (USA)
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference re-
ceived, including interference that may cause undesired operation.
The FCC requires the user to be notified that any changes or modifications not expressly approved by
RFM, Inc. may void the user’s authority to operate the equipment. While an application of the ZPM3570
module in a product is not required to obtain a new FCC authorization for the module, this does not pre-
clude the possibility that some other form of authorization or testing may be required for that end product.
This device using the integrated antenna has been tested to comply with FCC CFR Part 15. The device
meets the requirements for modular transmitter approval as detailed in the FCC public notice
DA00.1407.transmitter, given the following considerations:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
www.RFM.com
© 2011 by RF Monolithics, Inc.
• Lead and lead compounds
• Mercury and mercury compounds
• Chromium (VI)
• PBB (polybrominated biphenyl)
• PBDE (polybrominated biphenyl ether)
• Cadmium and cadmium compounds
• Maximum output power for the channels as defined by IEEE 802.15.4 [1] must be set to the
value below using emberSetRadioPower or equivalent under NORMAL mode as specified in [2].
- For channels 11 to 24, the value of -11
- For channel 25, the value of -17
- For channel 26, the value of -27
Duty cycle of 67% allowed.
The firmware disables power out if the source voltage is greater than 3.4 V.
VBATT must be between 2.4 and 3.4 V.
Technical support +1.678.684.2000
E-mail:
tech_sup@rfm.com
ZPM3570 Data Sheet - 05/25/11
Page 16 of 18

Related parts for ZPM3570-E