M25PE16-VMW6G Micron Technology Inc, M25PE16-VMW6G Datasheet - Page 36

• Manufacturer Part Number: M25PE16-VMW6G
• Manufacturer: Micron Technology Inc

Specifications of M25PE16-VMW6G

• Cell Type: NOR
• Density: 16Mb
• Access Time (max): 8ns
• Interface Type: Serial (SPI)
• Boot Type: Not Required
• Address Bus: 1b
• Operating Supply Voltage (typ): 3.3V
• Operating Temp Range: -40C to 85C
• Package Type: SOIC W
• Program/erase Volt (typ): 2.7 to 3.6V
• Sync/async: Synchronous
• Operating Temperature Classification: Industrial
• Operating Supply Voltage (min): 2.7V
• Operating Supply Voltage (max): 3.6V
• Word Size: 8b
• Number Of Words: 2M
• Supply Current: 12mA
• Mounting: Surface Mount
• Pin Count: 8
• Lead Free Status / Rohs Status: Compliant

Instructions
6.11
36/58
Write to lock register (WRLR)
The write to lock register (WRLR) instruction allows bits to be changed in the lock registers.
Before it can be accepted, a write enable (WREN) instruction must previously have been
executed. After the write enable (WREN) instruction has been decoded, the device sets the
write enable latch (WEL).
The write to lock register (WRLR) instruction is entered by driving Chip Select (S) Low,
followed by the instruction code, three address bytes (pointing to any address in the targeted
sector and one data byte on serial data input (D). The instruction sequence is shown in
Figure
latched in, otherwise the write to lock register (WRLR) instruction is not executed.
Lock register bits are volatile, and therefore do not require time to be written. When the write
to lock register (WRLR) instruction has been successfully executed, the write enable latch
(WEL) bit is reset after a delay time less than t
Any write to lock register (WRLR) instruction, while an erase, program or write cycle is in
progress, is rejected without having any effects on the cycle that is in progress.
Figure 16. Write to lock register (WRLR) instruction sequence
Table 10.
All sectors
S
C
D
16. Chip Select (S) must be driven High after the eighth bit of the data byte has been
Sector
Lock register in
0
1
2
Instruction
3
4
b7-b2
Bit
b1
b0
5
6
7
Sector lock down bit value (refer to
Sector write lock bit value (refer to
MSB
23
8
22 21
9 10
24-bit address
SHSL
3
28 29 30 31 32 33 34 35
2
minimum value.
1
0
MSB
7
Value
‘0’
6
Lock register
5
Table
Table
4
in
3
9)
36 37 38
9)
2
1
0
39
M25PE16
AI10784