M25PE16-VMW6G Micron Technology Inc, M25PE16-VMW6G Datasheet - Page 39

• Manufacturer Part Number: M25PE16-VMW6G
• Manufacturer: Micron Technology Inc

Specifications of M25PE16-VMW6G

• Cell Type: NOR
• Density: 16Mb
• Access Time (max): 8ns
• Interface Type: Serial (SPI)
• Boot Type: Not Required
• Address Bus: 1b
• Operating Supply Voltage (typ): 3.3V
• Operating Temp Range: -40C to 85C
• Package Type: SOIC W
• Program/erase Volt (typ): 2.7 to 3.6V
• Sync/async: Synchronous
• Operating Temperature Classification: Industrial
• Operating Supply Voltage (min): 2.7V
• Operating Supply Voltage (max): 3.6V
• Word Size: 8b
• Number Of Words: 2M
• Supply Current: 12mA
• Mounting: Surface Mount
• Pin Count: 8
• Lead Free Status / Rohs Status: Compliant

M25PE16
6.14
Subsector erase (SSE)
The subsector erase (SSE) instruction sets to ‘1’ (FFh) all bits inside the chosen subsector.
Before it can be accepted, a write enable (WREN) instruction must previously have been
executed. After the write enable (WREN) instruction has been decoded, the device sets the
write enable latch (WEL).
The subsector erase (SE) instruction is entered by driving Chip Select (S) Low, followed by
the instruction code, and three address bytes on serial data input (D). Any address inside
the subsector (see
Select (S) must be driven Low for the entire duration of the sequence.
The instruction sequence is shown in
Chip Select (S) must be driven High after the eighth bit of the last address byte has been
latched in, otherwise the subsector erase (SE) instruction is not executed. As soon as Chip
Select (S) is driven High, the self-timed subsector erase cycle (whose duration is t
initiated. While the subsector erase cycle is in progress, the status register may be read to
check the value of the write in progress (WIP) bit. The write in progress (WIP) bit is 1 during
the self-timed subsector erase cycle, and is 0 when it is completed. At some unspecified
time before the cycle is complete, the write enable latch (WEL) bit is reset.
A subsector erase (SSE) instruction applied to a subsector that contains a page that is
hardware or software protected is not executed.
Any subsector erase (SSE) instruction, while an erase, program or write cycle is in progress,
is rejected without having any effects on the cycle that is in progress.
If Reset (Reset) is driven Low while a subsector erase (SSE) cycle is in progress, the
subsector erase cycle is interrupted and data may not be erased correctly (see
Device status after a Reset Low
mode and a time of t
Chip Select (S) Low. For the value of t
Section 11: DC and AC
Figure 19. Subsector erase (SSE) instruction sequence
1. Address bits A23 to A21 are don’t care.
S
C
D
Table
RHSL
parameters.
0
4) is a valid address for the subsector erase (SE) instruction. Chip
is then required before the device can be re-selected by driving
1
2
Instruction
pulse). On Reset going Low, the device enters the reset
3
4
RHSL
Figure
5
6
see
7
18.
MSB
23 22
Table 21: Timings after a Reset Low pulse
8
9
24-bit address
2
29 30 31
1
0
Instructions
AI12356
Table 12:
SSE
) is
39/58
in