LH28F800SGN-L70 Sharp Electronics, LH28F800SGN-L70 Datasheet - Page 22

• Manufacturer Part Number: LH28F800SGN-L70
• Manufacturer: Sharp Electronics

Specifications of LH28F800SGN-L70

• Cell Type: NOR
• Density: 8Mb
• Interface Type: Parallel
• Boot Type: Not Required
• Address Bus: 19b
• Operating Supply Voltage (typ): 3.3/5V
• Operating Temp Range: 0C to 70C
• Package Type: SOP
• Program/erase Volt (typ): 2.7/3.3/5/12V
• Sync/async: Asynchronous
• Operating Temperature Classification: Commercial
• Operating Supply Voltage (min): 2.7/4.5V
• Operating Supply Voltage (max): 3.6/5.5V
• Word Size: 16b
• Number Of Words: 512K
• Supply Current: 65mA
• Mounting: Surface Mount
• Pin Count: 44
• Lead Free Status / Rohs Status: Not Compliant

FULL STATUS CHECK PROCEDURE
Clear Block Lock-Bits
Read Status Register
Clear Block Lock-Bits
Data (See Above)
Check if Desired
Status Register
Successful
Write D0H
Full Status
Write 60H
Complete
SR.4, 5 =
SR.7 =
SR.3 =
SR.1 =
SR.5 =
Read
Start
0
0
0
0
1
0
1
1
1
1
Clear Block Lock-Bits
Command Sequence
Device Protect Error
V
PP
Fig. 8 Clear Block Lock-Bits Flowchart
Range Error
Error
Error
- 22 -
OPERATION
OPERATION COMMAND
Write
Write
Read
Standby
Standby
Standby
Standby
Standby
Write FFH after the last clear block lock-bits operation to place
device in read array mode.
SR.5, SR.4, SR.3 and SR.1 are only cleared by the Clear
Status Register command.
If error is detected, clear the status register before attempting
retry or other error recovery.
BUS
BUS
COMMAND
Clear Block
Clear Block
Lock-Bits
Lock-Bits
Confirm
Setup
Check SR.3
1 = V
Check SR.4, 5
Both 1 = Command Sequence Error
Check SR.1
1 = Device Protect Detect
RP# = V
Permanent Lock-Bit is Set
Check SR.5
1 = Clear Block Lock-Bits Error
Data = 60H
Addr = X
Data = D0H
Addr = X
Status Register Data
Check SR.7
1 = WSM Ready
0 = WSM Busy
PP
Error Detect
LH28F800SG-L (FOR SOP)
IH
COMMENTS
or
COMMENTS