TDA7540B STMicroelectronics, TDA7540B Datasheet - Page 33

• Manufacturer Part Number: TDA7540B
• Manufacturer: STMicroelectronics

Specifications of TDA7540B

• Case: TQFP
• Dc: 06+
• Lead Free Status / Rohs Status: Compliant

DOCUMENT CD00108485
Copyright STMicroelectronics
TDA7540B
4.3.2
REVISION 1.0
Figure 7.
Functional description of the noise blanker
In the automotive environment spikes produced by the ignition or for example the wiper-
motor disturb the MPX-signal. The aim of the noise blanker part is to cancel the audible
influence of the spikes. Therefore the output of the stereo decoder is held at the actual
voltage for a time between 22
blanker is given in fig.15.
In a first stage the spikes must be detected but to avoid a wrong triggering on high
frequency (white) noise a complex trigger control is implemented. Behind the trigger stage a
pulse former generates the "blanking"-pulse. An own biasing circuit supplies the noise
blanker in order to avoid any cross talk to the signal path.
Trigger path
The incoming MPX signal is high pass filtered, amplified and rectified. This second order
high pass filter has a corner-frequency of 140kHz. The rectified signal, RECT, is low pass
filtered to generate a signal called PEAK. Also noise with a frequency 140kHz increases the
PEAK voltage. The resulting voltage can be adjusted by use of the noise rectifier discharge
current. The PEAK voltage is fed to a threshold generator, which adds to the PEAK-voltage
a DC-dependent threshold VTH. Both signals, RECT and PEAK+VTH are fed to a
comparator, which triggers a re-triggerable monoflop. The monoflop's output activates the
sample-and-hold circuits in the signal path for the selected duration.
Automatic noise controlled threshold adjustment (see
There are mainly two independent possibilities for programming the trigger threshold:
The low threshold is active in combination with a good MPX signal without any noise; the
PEAK voltage is less than 1V. The sensitivity in this operation is high.
If the MPX signal is noisy (low fieldstrength) the PEAK voltage increases due to the higher
noise, which is also rectified. With increasing of the PEAK voltage the trigger threshold
increases, too. This particular gain is programmable in 4 steps (NBCTH).
1. the low threshold in 8 steps (NBLTH)
2. and the noise adjusted threshold in 4 steps (NBCTH).
Highcut characteristics
Low pass
t i m e const ant
3 • D eem p
t D eem p
µ
s and 38
COMPANY INTERNAL
ACTIVE
V H C L
µ
s (programmable). The block diagram of the noise
V H C H
Fi el dst r engt h
Unauthorized reproduction and communication strictly prohibited
Figure
Functional description
DATE 11-May-2006
3)
29/75
page: 29/75