SC16C752IB48,151 NXP Semiconductors, SC16C752IB48,151 Datasheet - Page 26

• Manufacturer Part Number: SC16C752IB48,151
• Description: IC UART DUAL W/FIFO 48-LQFP
• Manufacturer: NXP Semiconductors

Specifications of SC16C752IB48,151

• Number Of Channels: 2, DUART
• Fifo's: 64 Byte
• Voltage - Supply: 2.5V, 3.3V, 5V
• With Auto Flow Control: Yes
• With False Start Bit Detection: Yes
• With Modem Control: Yes
• Mounting Type: Surface Mount
• Package / Case: 48-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 568-3289; 935270055151; SC16C752IB48-S

Philips Semiconductors
9397 750 11635
Product data
7.9 Interrupt identification register (IIR)
Table 16:
[1]
The IIR is a read-only 8-bit register which provides the source of the interrupt in a
prioritized manner.
Table 17:
The interrupt priority list is shown in
Bit
4
3
2
1
0
Bit
7-6
5
4
3-1
0
IER[7:4] can only be modified if EFR[4] is set, i.e., EFR[4] is a write enable. Re-enabling IER[1] will
not cause a new interrupt if the THR is below the threshold.
Symbol
IER[4]
IER[3]
IER[2]
IER[1]
IER[0]
Symbol
IIR[7:6]
IIR[5]
IIR[4]
IIR[3:1]
IIR[0]
Interrupt Enable Register bits description
Interrupt Identification Register bits description
[1]
Description
Sleep mode.
Modem Status Interrupt.
Receive Line Status interrupt.
Transmit Holding Register interrupt.
Receive Holding Register interrupt.
Description
Mirror the contents of FCR[0].
RTS/CTS LOW-to-HIGH change of state.
1 = Xoff/Special character has been detected.
3-bit encoded interrupt. See
Interrupt status.
Rev. 04 — 20 June 2003
Logic 0 = Disable sleep mode (normal default condition).
Logic 1 = Enable sleep mode. See
Logic 0 = Disable the modem status register interrupt (normal default
condition).
Logic 1 = Enable the modem status register interrupt.
Logic 0 = Disable the receiver line status interrupt (normal default
condition).
Logic 1 = Enable the receiver line status interrupt.
Logic 0 = Disable the THR interrupt (normal default condition).
Logic 1 = Enable the THR interrupt.
Logic 0 = Disable the RHR interrupt (normal default condition).
Logic 1 = Enable the RHR interrupt.
Logic 0 = An interrupt is pending.
Logic 1 = No interrupt is pending.
Table 17
shows interrupt identification register bit settings.
Table
18.
Table
18.
Section 6.7 “Sleep mode”
…continued
© Koninklijke Philips Electronics N.V. 2003. All rights reserved.
Dual UART with 64-byte FIFO
SC16C752
for details.
26 of 47