ADRF6602ACPZ-R7 Analog Devices Inc, ADRF6602ACPZ-R7 Datasheet - Page 8

• Manufacturer Part Number: ADRF6602ACPZ-R7
• Manufacturer: Analog Devices Inc

Specifications of ADRF6602ACPZ-R7

• Lead Free Status / Rohs Status: Compliant

ADRF6602
Pin No.
22
26
27
29
32, 33
36
37, 38
39
40
Mnemonic
VCC_MIX
RF
VCC_V2I
IP3SET
NC
LODRV_EN
LON, LOP
VTUNE
DECLVCO
EPAD
IN
Description
Power Supply. Power supply voltage range is 4.75 V to 5.25 V. Each power supply pin should be decoupled
with a 100 pF capacitor and a 0.1 μF capacitor located close to the pin.
RF Input (Single-Ended, 50 Ω).
Power Supply. Power supply voltage range is 4.75 V to 5.25 V. Each power supply pin should be decoupled
with a 100 pF capacitor and a 0.1 μF capacitor located close to the pin.
Connect a resistor from this pin to a 5 V supply to adjust IIP3. Normally leave open.
No Connection.
LO Driver Enable. Together with Pin 16 (PLL_EN), this digital input pin determines whether the LOP and LON
pins operate as inputs or outputs. LOP and LON become inputs if the PLL_EN pin is low or if the PLL_EN pin
is set high with the PLEN bit (DB6 in Register 5) set to 0. LOP and LON become outputs if either the LODRV_EN
pin or the LDRV bit (DB3 in Register 5) is set to 1 while the PLL_EN pin is set high. External LO drive frequency
must be 1× LO. This pin should not be left floating.
Local Oscillator Input/Output. The internally generated 1× LO is available on these pins. When internal LO
generation is disabled, an external 1× LO can be applied to these pins.
VCO Control Voltage Input. This pin is driven by the output of the loop filter. Nominal input voltage range on
this pin is 1.5 V to 2.5 V.
Decoupling Node for VCO LDO. Connect a 100 pF capacitor and a 10 μF capacitor between this pin and ground.
Exposed Paddle. The exposed paddle should be soldered to a low impedance ground plane.
Rev. C | Page 8 of 32