TDA8922CTH/N1,112 NXP Semiconductors, TDA8922CTH/N1,112 Datasheet - Page 21

• Manufacturer Part Number: TDA8922CTH/N1,112
• Description: IC AMP AUDIO CLASS D 24HSOP
• Manufacturer: NXP Semiconductors
• Type: Class Dr

Specifications of TDA8922CTH/N1,112

• Output Type: 1-Channel (Mono) or 2-Channel (Stereo)
• Package / Case: 24-HSOP
• Max Output Power X Channels @ Load: 155W x 1 @ 8 Ohm; 75W x 2 @ 6 Ohm
• Voltage - Supply: ±12.5 V ~ 32.5 V
• Features: Depop, Differential Inputs, Mute, Short-Circuit and Thermal Protection, Standby
• Mounting Type: Surface Mount
• Product: Class-D
• Output Power: 155 W
• Available Set Gain: 36 dB
• Common Mode Rejection Ratio (min): 75 dB
• Thd Plus Noise: 0.02 %
• Mounting Style: SMD/SMT
• Audio Load Resistance: 8 Ohms
• Dual Supply Voltage: +/- 30 V
• Input Signal Type: Single
• Output Signal Type: Differential, Single
• Supply Type: Dual
• Lead Free Status / RoHS Status: Lead free by exemption / RoHS compliant by exemption
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free by exemption / RoHS compliant by exemption
• Other names: 935286885112

NXP Semiconductors
TDA8922C_1
Product data sheet
13.7 Application schematic
The most effective way to avoid pumping effects is to connect the TDA8922C in a mono
full-bridge configuration. In the case of stereo single-ended applications, it is advised to
connect the inputs in anti-phase (see
be adapted; for example, by increasing the values of the supply line decoupling
capacitors.
Notes on the application schematic:
•
•
•
•
•
•
Connect a solid ground plane around the switching amplifier to avoid emissions
Place 100 nF capacitors as close as possible to the TDA8922C power supply pins
Connect the heatsink to the ground plane or to VSSPn using a 100 nF capacitor
Use a thermally conductive, electrically non-conductive, Sil-Pad between the
TDA8922C heat spreader and the external heatsink
The heat spreader of the TDA8922C is internally connected to VSSD
Use differential inputs for the most effective system level audio performance with
unbalanced signal sources. In case of hum due to floating inputs, connect the
shielding or source ground to the amplifier ground.
Rev. 01 — 7 September 2009
Section 8.4 on page
2
11). The power supply can also
75 W class-D power amplifier
TDA8922C
© NXP B.V. 2009. All rights reserved.
21 of 40