AT32UC3A464 Atmel Corporation, AT32UC3A464 Datasheet - Page 580

• Manufacturer Part Number: AT32UC3A464
• Manufacturer: Atmel Corporation

Specifications of AT32UC3A464

• Flash (kbytes): 64 Kbytes
• Pin Count: 100
• Max. Operating Frequency: 66 MHz
• Cpu: 32-bit AVR
• Hardware Qtouch Acquisition: No
• Usb Transceiver: 1
• Usb Speed: Hi-Speed
• Usb Interface: Device + OTG
• Spi: 6
• Twi (i2c): 2
• Uart: 4
• Ssc: 1
• Sd / Emmc: 2
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 128
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.0 to 3.6
• Operating Voltage (vcc): 3.0 to 3.6
• Fpu: No
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

Figure 25-45. Master Node Configuration, NACT=PUBLISH
32072G–11/2011
TXRDY
RXRDY
LINTC
Write
LINIR
THR
Write
Break
Header
Synch
• Case 1: NACT=PUBLISH, the USART sends a response
• Case 2: NACT=SUBSCRIBE, the USART receives a response
• Case 3: NACT=IGNORE, the USART is not concerned by a response
– Wait until TXRDY is a one
– Send a byte by writing to THR.TXCHR
– Repeat the two previous steps until there is no more data to send
– Wait until CSR.LINTC is a one
– Check for LIN errors
– Wait until RXRDY is a one
– Read RHR.RXCHR
– Repeat the two previous steps until there is no more data to read
– Wait until LINTC is a one
– Check for LIN errors
– Wait until LINTC is a one
– Check for LIN errors
Data 1
Protected
Identifier
Data3
Frame slot = TFrame_Maximum
Response
space
Data 2
Frame
Data 1
Data 3
Data N
Response
Data N-1
Data N
Checksum
FSDIS=1
space
frame
Inter-
FSDIS=0
580