AT89C51RE2 Atmel Corporation, AT89C51RE2 Datasheet - Page 23

• Manufacturer Part Number: AT89C51RE2
• Manufacturer: Atmel Corporation

Specifications of AT89C51RE2

• Flash (kbytes): 128 Kbytes
• Max. Operating Frequency: 60 MHz
• Cpu: 8051-12C
• Max I/o Pins: 34
• Spi: 1
• Uart: 2
• Sram (kbytes): 8.25
• Self Program Memory: API
• Operating Voltage (vcc): 2.7 to 5.5
• Timers: 4
• Isp: UART/OCD
• Watchdog: Yes

7663E–8051–10/08
•
•
The stack pointer (SP) may be located anywhere in the 256 bytes RAM (lower and upper RAM)
internal data memory. The stack may be located in the 256 lower bytes of the XRAM by activat-
ing the extended stack mode (see EES bit in AUXR1).
The M0 bit allows to stretch the XRAM timings; if M0 is set, the read and write pulses are
extended from 6 to 30 clock periods. This is useful to access external slow peripherals.
With EXTRAM = 0, the XRAM is indirectly addressed, using the MOVX instruction in
combination with any of the registers R0, R1 of the selected bank or DPTR. An access to
XRAM will not affect ports P0, P2, P3.6 (WR) and P3.7 (RD). For example, with EXTRAM =
0, MOVX @R0, # data where R0 contains 0A0H, accesses the XRAM at address 0A0H
rather than external memory. An access to external data memory locations higher than the
accessible size of the XRAM will be performed with the MOVX DPTR instructions in the
same way as in the standard 80C51, with P0 and P2 as data/address busses, and P3.6 and
P3.7 as write and read timing signals. Accesses to XRAM above 0FFH can only be done by
the use of DPTR.
With EXTRAM = 1, MOVX @Ri and MOVX @DPTR will be similar to the standard
80C51.MOVX @ Ri will provide an eight-bit address multiplexed with data on Port0 and any
output port pins can be used to output higher order address bits. This is to provide the
external paging capability. MOVX @DPTR will generate a sixteen-bit address. Port2 outputs
the high-order eight address bits (the contents of DPH) while Port0 multiplexes the low-order
eight address bits (DPL) with data. MOVX @ Ri and MOVX @DPTR will generate either
read or write signals on P3.6 (WR) and P3.7 (RD).
AT89C51RE2
23