SAM3N4C Atmel Corporation, SAM3N4C Datasheet - Page 292

• Manufacturer Part Number: SAM3N4C
• Manufacturer: Atmel Corporation

Specifications of SAM3N4C

• Flash (kbytes): 256 Kbytes
• Pin Count: 100
• Max. Operating Frequency: 48 MHz
• Cpu: Cortex-M3
• # Of Touch Channels: 32
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 79
• Ext Interrupts: 79
• Quadrature Decoder Channels: 2
• Usb Speed: No
• Usb Interface: No
• Spi: 3
• Twi (i2c): 2
• Uart: 4
• Ssc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 16
• Adc Resolution (bits): 10
• Adc Speed (ksps): 384
• Resistive Touch Screen: No
• Dac Channels: 1
• Dac Resolution (bits): 10
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 24
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.62 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

Table 19-1.
Notes:
292
Signal Name
VDDIO
VDDCORE
VDDPLL
GND
XIN
TST
PGMEN0
PGMEN1
PGMEN2
PGMNCMD
PGMRDY
PGMNOE
PGMNVALID
PGMM[3:0]
PGMD[15:0] or [7:0]
1. DATA[7:0] pertains to the SAM3NxA (48 bits).
2. PGMD[7:0] pertains to the SAM3NxA (48 bits).
SAM3N
Signal Description List
(2)
Function
I/O Lines Power Supply
Core Power Supply
PLL Power Supply
Ground
Main Clock Input.
This input can be tied to GND. In this case, the
device is clocked by the internal RC oscillator.
Test Mode Select
Test Mode Select
Test Mode Select
Test Mode Select
Valid command available
0: Device is busy
1: Device is ready for a new command
Output Enable (active high)
0: DATA[15:0] or DATA[7:0]
1: DATA[15:0] or DATA[7:0]
Specifies DATA type (See
Bi-directional data bus
Table
(1)
(1)
is in input mode
is in output mode
19-2)
Clocks
Power
Test
PIO
Input/Output
Ground
Output
Output
Power
Power
Power
Type
Input
Input
Input
Input
Input
Input
Input
Input
Active
Level
High
High
High
High
Low
Low
Low
Low
Comments
32KHz to 50MHz
Must be connected to VDDIO
Must be connected to VDDIO
Must be connected to VDDIO
Must be connected to GND
Pulled-up input at reset
Pulled-up input at reset
Pulled-up input at reset
Pulled-up input at reset
Pulled-up input at reset
Pulled-up input at reset
11011A–ATARM–04-Oct-10