SAM9261 Atmel Corporation, SAM9261 Datasheet - Page 548

• Manufacturer Part Number: SAM9261
• Manufacturer: Atmel Corporation

Specifications of SAM9261

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 240 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Ssc: 3
• Sd / Emmc: 1
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: No
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 160
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.08 to 1.32
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

35.7.2
35.7.3
6062N–ATARM–3-Oct-11
Data Transfer Operation
Read Operation
Figure 35-7. Command/Response Functional Flow Diagram
Note:
The MultiMedia Card allows several read/write operations (single block, multiple blocks, stream,
etc.). These kind of transfers can be selected setting the Transfer Type (TRTYP) field in the MCI
Command Register (MCI_CMDR).
These operations can be done using the features of the Peripheral DMA Controller (PDC). If the
PDCMODE bit is set in MCI_MR, then all reads and writes use the PDC facilities.
In all cases, the block length (BLKLEN field) must be defined in the mode register MCI_MR. This
field determines the size of the data block.
The following flowchart shows how to read a single block with or without use of PDC facilities. In
this example (see
If the command is SEND_OP_COND, the CRC error flag is always present (refer to R3 response
in the MultiMedia Card specification).
Check error bits in the
Wait for command
status register
ready status flag
Figure
35-8), a polling method is used to wait for the end of read. Similarly, the
(1)
Set the command argument
MCI_ARGR = Argument
Read response if required
MCI_CMDR = Command
Status error flags?
Set the command
Read MCI_SR
RETURN OK
CMDRDY
1
(1)
RETURN ERROR (1)
AT91SAM9261
Yes
0
548