SAM9261 Atmel Corporation, SAM9261 Datasheet - Page 702

• Manufacturer Part Number: SAM9261
• Manufacturer: Atmel Corporation

Specifications of SAM9261

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 240 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Ssc: 3
• Sd / Emmc: 1
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: No
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 160
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.08 to 1.32
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

42.2.11.2
42.2.11.3
42.2.11.4
702
AT91SAM9261
SSC: Periodic Transmission Limitations in Master Mode
SSC: Last RK Clock Cycle when RK Outputs a Clock During Data Transfer
SSC: First RK Clock Cycle when Rk Outputs a Clock During Data Transfer
The data need to be delayed for one bit clock period with an external assembly.
In the following schematic, TD, TK and NRST are AT91SAM9261 signals, TXD is the delayed
data to connect to the device.
If the Least Significant Bit is sent first (MSBF = 0) the first TAG during the frame synchro is not
sent.
None.
When the SSC receiver is used with the following conditions:
At the end of the data, the RK pin is set in high impedance which might be seen as an unex-
pected clock cycle.
Enable the pull-up on RK pin.
When the SSC receiver is used with the following conditions:
The first clock cycle time generated by the RK pin is equal to MCK/(2 x (value +1)).
None.
• the internal clock divider is used (CKS = 0 and DIV different from 0)
• RK pin set as output and provides the clock during data transfer (CKO = 2)
• data sampled on RK falling edge (CKI = 0),
• RX clock is divided clock (CKS = 0 and DIV different from 0)
• RK pin set as output and provides the clock during data transfer (CKO = 2)
• data sampled on RK falling edge (CKI = 0),
Problem Fix/Workaround
Problem Fix/Workaround
Problem Fix/Workaround
Problem Fix/Workaround
6062N–ATARM–3-Oct-11