SAM9RL64 Atmel Corporation, SAM9RL64 Datasheet - Page 17

• Manufacturer Part Number: SAM9RL64
• Manufacturer: Atmel Corporation

Specifications of SAM9RL64

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 240 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 118
• Ext Interrupts: 118
• Usb Transceiver: 1
• Usb Speed: Hi-Speed
• Usb Interface: Device
• Spi: 1
• Twi (i2c): 2
• Uart: 5
• Ssc: 2
• Sd / Emmc: 1
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 6
• Adc Resolution (bits): 10
• Adc Speed (ksps): 220
• Resistive Touch Screen: Yes
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 64
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.08 to 1.32
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

5.2
6289CS–ATARM–28-May-09
Programmable I/O Lines Power Supplies
Figure 5-1.
The power supplies pins VDDIOM support two voltage ranges. This allows the device to reach
its maximum speed either out of 1.8V or 3.3V external memories.
The maximum speed is MCK on the pin SDCK (SDRAM Clock) loaded with 30pF for power sup-
ply at 1.8V and 50 pF for power supply at 3.3V.
The maximum speed on the other signals of the External Bus Interface (control, address and
data signals) is 50 MHz.
The voltage ranges are determined by programming registers in the Chip Configuration registers
located in the Matrix User Interface.
At reset, the selected voltage defaults to 3.3V nominal and power supply pins can accept either
1.8V or 3.3V. The user must make sure to program the EBI voltage range before getting the
device out of its Slow Clock Mode.
The PIO lines are supplied through VDDIOP and the speed of the signal that can be driven on
them can reach 50 MHz with 50 pF load.
VIN
10µF
Example of PLL and USB Power Supplies
1V2_USB
1V2_USB
3V3
VIN
CE
VSS
2.2µH
2.2µH
2.2µH
MIC5235YM5
VOUT
ADJ
0.1µF
0.1µF
0.1µF
AT91SAM9R64/RL64
VDDPLLB
VDDUTMIC
VDDUTMII
1K
100K
10µF
0.1µF
1V2_USB
17