SAM9RL64 Atmel Corporation, SAM9RL64 Datasheet - Page 46

• Manufacturer Part Number: SAM9RL64
• Manufacturer: Atmel Corporation

Specifications of SAM9RL64

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 240 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 118
• Ext Interrupts: 118
• Usb Transceiver: 1
• Usb Speed: Hi-Speed
• Usb Interface: Device
• Spi: 1
• Twi (i2c): 2
• Uart: 5
• Ssc: 2
• Sd / Emmc: 1
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 6
• Adc Resolution (bits): 10
• Adc Speed (ksps): 220
• Resistive Touch Screen: Yes
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 64
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.08 to 1.32
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

11.7
11.8
11.9
46
Pulse Width Modulation Controller (PWM)
Multimedia Card Interface (MCI)
USB High Speed Device Port (UDPHS)
AT91SAM9R64/RL64
• Each channel is user-configurable and contains:
• Two global registers that act on all three TC Channels
• 4 channels, one 16-bit counter per channel
• Common clock generator, providing Thirteen Different Clocks
• Independent channel programming
• Compatibility with MultiMedia Card Specification Version 3.31
• Compatibility with SD Memory Card Specification Version 1.0
• Compatibility with SDIO Specification Version V1.1
• Cards clock rate up to Master Clock divided by 2
• Embedded power management to slow down clock rate when not used
• MCI has one slot supporting
• Support for stream, block and multi-block data read and write
• USB V2.0 high-speed compliant, 480 MBits per second
• Embedded USB V2.0 UTMI+ high-speed transceiver
• Embedded 4K-byte dual-port RAM for endpoints
• Embedded 6 channels DMA controller
• Suspend/Resume logic
• Up to 3 banks for isochronous and bulk endpoints
• Seven endpoints:
– Delay Timing
– Pulse Width Modulation
– Up/down Capabilities
– Three external clock inputs
– Five internal clock inputs
– Two multi-purpose input/output signals
– A Modulo n counter providing eleven clocks
– Two independent Linear Dividers working on modulo n counter outputs
– Independent Enable Disable Commands
– Independent Clock Selection
– Independent Period and Duty Cycle, with Double Bufferization
– Programmable selection of the output waveform polarity
– Programmable center or left aligned output waveform
– One MultiMediaCard bus (up to 30 cards) or
– One SD Memory Card
– One SDIO Card
6289CS–ATARM–28-May-09