SAM9RL64 Atmel Corporation, SAM9RL64 Datasheet - Page 2

• Manufacturer Part Number: SAM9RL64
• Manufacturer: Atmel Corporation

Specifications of SAM9RL64

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 240 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 118
• Ext Interrupts: 118
• Usb Transceiver: 1
• Usb Speed: Hi-Speed
• Usb Interface: Device
• Spi: 1
• Twi (i2c): 2
• Uart: 5
• Ssc: 2
• Sd / Emmc: 1
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 6
• Adc Resolution (bits): 10
• Adc Speed (ksps): 220
• Resistive Touch Screen: Yes
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 64
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.08 to 1.32
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
2
Power Management Controller (PMC)
Advanced Interrupt Controller (AIC)
Debug Unit (DBGU)
Periodic Interval Timer (PIT)
Watchdog Timer (WDT)
Real-time Timer (RTT)
Real-time Clock (RTC)
One 6-channel 10-Bit Analog-to-Digital Converter
Four 32-bit Parallel Input/Output Controllers (PIOA, PIOB, PIOC and PIOD)
22-channel Peripheral DMA Controller (PDC)
One MultiMedia Card Interface (MCI)
Two Synchronous Serial Controllers (SSC)
One AC97 Controller (AC97C)
Four Universal Synchronous/Asynchronous Receiver Transmitters (USART)
One Master/Slave Serial Peripheral Interface (SPI)
One Three-channel 16-bit Timer/Counter (TC)
One Four-channel 16-bit PWM Controller (PWMC)
Two Two-wire Interfaces (TWI)
– One PLL 480 MHz Optimized for USB HS
– Very Slow Clock Operating Mode, Software Programmable Power Optimization Capabilities
– Two Programmable External Clock Signals
– Individually Maskable, Eight-level Priority, Vectored Interrupt Sources
– One External Interrupt Sources and One Fast Interrupt Source, Spurious Interrupt Protected
– 2-wire UART and Support for Debug Communication Channel, Programmable ICE Access Prevention
– Mode for General Purpose 2-wire UART Serial Communication
– 20-bit Interval Timer plus 12-bit Interval Counter
– Key-protected, Programmable Only Once, Windowed 16-bit Counter Running at Slow Clock
– 32-bit Free-running Backup Counter Running at Slow Clock with 16-bit Prescaler
– Time, Date and Alarm 32-bit Parallel Load
– Low Power Consumption
– Programmable Periodic Interrupt
– Touch Screen Interface Compatible with Industry Standard 4-wire Sensitive Touch Panels
– 118 Programmable I/O Lines Multiplexed with up to Two Peripheral I/Os for 217-ball BGA Package
– Input Change Interrupt Capability on Each I/O Line
– Individually Programmable Open-drain, Pull-up Resistor and Synchronous Output
– SDCard/SDIO 1.0 and MultiMediaCard
– Automatic Protocol Control and Fast Automatic Data Transfers with PDC
– Independent Clock and Frame Sync Signals for Each Receiver and Transmitter
– I²S Analog Interface Support, Time Division Multiplex Support
– High-speed Continuous Data Stream Capabilities with 32-bit Data Transfer
– 6-channel Single AC97 Analog Front End Interface, Slot Assigner
– Individual Baud Rate Generator, IrDA
– Support for ISO7816 T0/T1 Smart Card, Hardware Handshaking, RS485 Support
– 8- to 16-bit Programmable Data Length, Four External Peripheral Chip Selects
– High-speed Synchronous Communications
– Three External Clock Inputs, Two Multi-purpose I/O Pins per Channel
– Double PWM Generation, Capture/Waveform Mode, Up/Down Capability
– Compatible with Standard Two-wire Serial Memories
– One, Two or Three Bytes for Slave Address
– Sequential Read/Write Operations
AT91SAM9R64/RL64
®
™
Infrared Modulation/Demodulation, Manchester Encoding/Decoding
4.3 Compliant
6289CS–ATARM–28-May-09