LPC1226FBD48 NXP Semiconductors, LPC1226FBD48 Datasheet - Page 2

The LPC1226FBD48 is an ARM Cortex-M0 based microcontroller for embedded applications featuring a high level of integration and low power consumption

LPC1226FBD48

Manufacturer Part Number
LPC1226FBD48
Description
The LPC1226FBD48 is an ARM Cortex-M0 based microcontroller for embedded applications featuring a high level of integration and low power consumption
Manufacturer
NXP Semiconductors
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
LPC1226FBD48/301
Manufacturer:
ROHM
Quantity:
12 000
Part Number:
LPC1226FBD48/301,1
Manufacturer:
NXP Semiconductors
Quantity:
10 000
NXP Semiconductors
LPC122X
Product data sheet
Digital peripherals
Analog peripherals
Power
Unique device serial number for identification.
3.3 V power supply.
Available as 64-pin and 48-pin LQFP package.
Crystal oscillator with an operating range of 1 MHz to 25 MHz.
12 MHz Internal RC (IRC) oscillator trimmed to 1 % accuracy that can optionally be
used as a system clock.
PLL allows CPU operation up to the maximum CPU rate without the need for a
high-frequency crystal. May be run from the system oscillator or the internal RC
oscillator.
Clock output function with divider that can reflect the system oscillator clock, IRC
clock, main clock, and Watchdog clock.
Real-Time Clock (RTC).
Micro DMA controller with 21 channels.
CRC engine.
Two UARTs with fractional baud rate generation and internal FIFO. One UART with
RS-485 and modem support and one standard UART with IrDA.
SSP/SPI controller with FIFO and multi-protocol capabilities.
I
data rate of 1 Mbit/s with multiple address recognition and monitor mode. I
pins have programmable glitch filter.
Up to 55 General Purpose I/O (GPIO) pins with programmable pull-up resistor,
open-drain mode, programmable digital input glitch filter, and programmable input
inverter.
Programmable output drive on all GPIO pins. Four pins support high-current output
drivers.
All GPIO pins can be used as edge and level sensitive interrupt sources.
Four general purpose counter/timers with four capture inputs and four match
outputs (32-bit timers) or two capture inputs and two match outputs (16-bit timers).
Windowed WatchDog Timer (WWDT); IEC-60335 Class B certified.
One 8-channel, 10-bit ADC.
Two highly flexible analog comparators. Comparator outputs can be programmed
to trigger a timer match signal or can be used to emulate 555 timer behavior.
Three reduced power modes: Sleep, Deep-sleep, and Deep power-down.
Processor wake-up from Deep-sleep mode via start logic using 12 port pins.
Processor wake-up from Deep-power down and Deep-sleep modes via the RTC.
Brownout detect with three separate thresholds each for interrupt and forced reset.
Power-On Reset (POR).
Integrated PMU (Power Management Unit).
2
C-bus interface supporting full I
All information provided in this document is subject to legal disclaimers.
Rev. 2 — 26 August 2011
2
C-bus specification and Fast-mode Plus with a
32-bit ARM Cortex-M0 microcontroller
LPC122x
© NXP B.V. 2011. All rights reserved.
2
C-bus
2 of 61

Related parts for LPC1226FBD48