STM32F101C8 STMicroelectronics, STM32F101C8 Datasheet - Page 81

• Manufacturer Part Number: STM32F101C8
• Description: Mainstream Access line, ARM Cortex-M3 MCU with 64 Kbytes Flash, 36 MHz CPU
• Manufacturer: STMicroelectronics

Specifications of STM32F101C8

• Peripherals Supported: timers, ADC, SPIs, I2Cs and USARTs
• Conversion Range: 0 to 3.6 V
• Systick Timer: 24-bit downcounter

STM32F101x8, STM32F101xB
Table 54.
18-Oct-2007
Date
Document revision history (continued)
Revision
3
V
Note added below
characteristics. and below
parameter description modified.
Table 42: ADC characteristics
conditions
Figure 33: ADC accuracy characteristics
Packages are ECOPACK® compliant.
Tables modified in
ADC and ANTI_TAMPER signal names modified (see
density STM32F101xx pin
STM32F101xx pin definitions
updated in
V
Updated:
characteristics.
t
down.
Typical values modified, note 2 modified and note 3 removed in
Low-power mode wakeup
Maximum current consumption
T
T
Handling of unused pins specified in
on page
Table 4: Medium-density STM32F101xx pin
and
Internal LSI RC frequency changed from 32 to 40 kHz (see
oscillator
wakeup
and data
Option byte addresses corrected in
ACC
t
Appendix A: Important notes on page 71
Added:
characteristics.
Note added below
Values added and notes added in
current consumptions in Stop and Standby
On-chip peripheral current consumption on page 43
Package mechanical data inch values are calculated from mm and
rounded to 4 decimal digits (see
V
VDD
JITTER
S_temp
S_vrefint
ESD(CDM)
hys
prog
Note 7
HSI
Doc ID 13586 Rev 14
modified in
modified in
added to
removed from
Figure
added to
timings. N
modified in
54. All I/Os are CMOS and TTL compliant.
added to
retention.
characteristics). Values added to
Table 29: EMS characteristics
modified.
value added to
Table 21: Typical current consumption in Standby
modified.
13,
Table 27: Flash memory
Table 34: I/O static
Table 9: Operating conditions at power-up / power-
Table 46: TS
END
Section 5.3.5: Supply current
Table 11: Embedded internal reference
Figure
Table 10: Embedded reset and power control block
Table 35: Output voltage characteristics
Table 23: HSI oscillator
Table 26: PLL
modified in
14,
timings.
Table 31: ESD absolute maximum
Table 21: HSE 4-16 MHz oscillator
definitions).
Figure 16
modified. Note 4 removed and values
and
characteristics.
Changes
Table
Section 6: Package
Table 15: Typical and maximum
Table 28: Flash memory endurance
Table 44: ADC accuracy - limited test
Figure 8: Memory
characteristics.
General input/output characteristics
characteristics.
12,
Table 4: Medium-density
and
characteristics.
and
modified.
Table 13
added.
Table 25: Low-power mode
modes.
characteristics.
definitions: table clarified
Figure
Table 30: EMI
characteristics.
and
18.
added.
characteristics).
Revision history
map.
Table 4: Medium-
Table 14
voltage.
Table 24: LSI
and V
mode.
ratings.
Table 25:
updated.
OH
81/87