ST10R272L STMicroelectronics, ST10R272L Datasheet - Page 32
![no-image](/images/manufacturer_photos/0/6/637/stmicroelectronics_sml.jpg)
ST10R272L
Manufacturer Part Number
ST10R272L
Description
16-BIT Romless MCU WITH MAC UNIT
Manufacturer
STMicroelectronics
Datasheet
1.ST10R272L.pdf
(77 pages)
Specifications of ST10R272L
Cpu Frequency
0 to 50 MHz
Power
3.3 Volt +/-0.3V
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
ST10R272LT1
Manufacturer:
PANASONIC
Quantity:
30 000
Part Number:
ST10R272LT1
Manufacturer:
ST
Quantity:
20 000
Company:
Part Number:
ST10R272LT1/TR
Manufacturer:
STMicroelectronics
Quantity:
10 000
Company:
Part Number:
ST10R272LT6
Manufacturer:
CYPRESS
Quantity:
1 400
Part Number:
ST10R272LT6
Manufacturer:
ST
Quantity:
20 000
ST10R272L - WATCHDOG TIMER
12
The Watchdog Timer is a fail-safe mechanism which limits the malfunction time of the
controller. The Watchdog Timer is always enabled after device reset and can only be disabled
in the time interval until the EINIT (end of initialization) instruction has been executed. In this
way, the chip’s start-up procedure is always monitored. The software must be designed to
service the Watchdog Timer before it overflows. If, due to hardware or software related
failures, the software fails to maintain the Watchdog Timer, it will overflow generating an
internal hardware reset and pulling the RSTOUT pin low to reset external hardware
components.
The Watchdog Timer is a 16-bit timer, clocked with the system clock divided either by 2 or by
128. The high byte of the Watchdog Timer register can be set to a pre-specified reload value
(stored in WDTREL) in order to allow further variation of the monitored time interval. Each
time it is serviced by the application software, the high byte of the Watchdog Timer is
reloaded. The table below shows the watchdog time range which for a 50MHz CPU clock
rounded to 3 significant figures.
32/77
1
SSPCKS Value
011
100
101
110
111
Reload value
in WDTREL
FF
00
H
H
WATCHDOG TIMER
Table 11 Synchronous baud rate and SSPCKS reload values
SSP clock = CPU clock divided by 16
SSP clock = CPU clock divided by 32
SSP clock = CPU clock divided by 64
SSP clock = CPU clock divided by 128
SSP clock = CPU clock divided by 256
Table 12 Watchdog timer range
Prescaler for f
2 (WDTIN = ‘0’)
10.24 µs
2.62 ms
CPU
128 (WDTIN = ‘1’)
655 µs
168 ms
Synchronous baud rate
3.13 MBit/s
1.56 MBit/s
781 KBit/s
391 KBit/s
195 KBit/s