TLE 8264-2E Infineon Technologies, TLE 8264-2E Datasheet - Page 67

• Manufacturer Part Number: TLE 8264-2E
• Manufacturer: Infineon Technologies

Specifications of TLE 8264-2E

• Packages: PG-DSO-36
• Transceiver: High Speed CAN ISO 11898 - 5 / 3 x LIN2.0 / J2602
• Voltage Regulator Output: 2 x 200 mA + 400 mA
• Watchdog: Standard and Window Watchdog
• Quiescent Current (max.): 28 ?A (typ) Sleep Mode (5V on)
• Standby Current: 58 ?A (typ) Stop Mode (5V on)

Figure 33
13.2.3
The LH_PL/Test pin is used to set the SBC chip into SBC Software Development Mode. When the Test pin is
connected to GND, the SBC starts in SBC Software Development Mode. When the pin is left open, or connected
to
up resistor (switched ON only during SBC Init Mode) to prevent the SBC device from starting in SBC Software
Development Mode during normal life of the vehicle, as for example when the battery has been disconnected. To
avoid disturbance, the LH_PL/Test pin is monitored during the Init Mode (from the time
is left). If the pin is low for the Init Mode time, Software Development Mode is reached. The mode is stored during
the complete time where
back to SBC OFF mode.
Data Sheet
V
s
the SBC starts into normal operation. Please refer to
LH_PL/ Test block diagram
Test Pin
LH_ PL / test
V
S
is above
V
S
V
R
UVOFF
LH_ PL
. It means to leave Software Development Mode, the SBC must go
T
T
test
LH_PL
67
Limp home
SBC Init
Figure
mode
3. The LH_PL/Test pin has an integrated pull-
LH_P L_test. vsd
V
S
>
Rev. 1.0, 2009-03-31
V
UVON
TLE8264-2E
until Init Mode
Limp Home