SD1010-1199A N/A, SD1010-1199A Datasheet - Page 16

• Manufacturer Part Number: SD1010-1199A
• Description: Analog-Interface XGA TFT LCD Display Controller
• Manufacturer: N/A

3.3.
The SD1010A supports both automatic image scaling and interpolation.
3.3.1.
The SD1010A supports several different input modes, and the input image may have
different sizes. It is essential to support automatic image scaling so that the input
image is always displayed to the full screen regardless the input mode. The SD1010A
scales the images in both horizontal and vertical directions. It calculates the correct
scaling ratio for both directions based upon the LCD panel resolution and the input
mode and timing information produced by the “Input mode detection & auto
calibration” block. The scaling ratio is re-adjusted whenever a different input mode is
detected. The ratio is then fed to the buffer memory read control logic to fetch the
image data with the right sequence and timing. Some of the image data may be read
more than once to achieve the scaling effect.
3.3.2.
The SD1010A supports image interpolation to achieve better image quality. A basic
image scaling algorithm replicates the input images to achieve the scaling effect. The
replication scheme usually results in a poor image quality. The SD1010A implements
a proprietary interpolation algorithm to improve the image quality. The programmable
interpolation is implemented with a 256-entry mapping table in the EEPROM to allow
system users to adjust the bi-linear interpolation parameters to control the sharpness
and smoothness quality of the image. In the default setting, the mapping table
contains a straight line of slope equal to 1, i.e. the data in entry N equal to the value
N. If the mapping table contains a line of slope equal to 2, then the output image will
be a bit sharper than the image generated by a table with the default setting. Through
an external microcontroller, users can chose among different interpolation algorithm.
3.3.3.
The SD1010A supports 16.7 million true colors for a 6-bit panel. Two dithering
algorithms are implemented and users can chose between them through the external
microcontroller. The first one is area-based dithering, and the second one is a frame-
based frame modulation, which also is called frame rate control. Through the external
microcontroller, users can choose among different dithering algorithms.
3.3.4.
In order to generate a good picture, the SD1010A incorporate a proprietary scheme to
detect text and non-text picture. Then applying the appropriate process to improve the
text image based on the detection of incoming source. By using the text enhancement
November, 1999
Revision B
SmartASIC, Inc.
Image scaling, interpolation and dithering block
Image scaling
Image interpolation
Dithering
Text Enhancement
SmartASIC Confidential
SD1010A
16