NL10276AC30_04L NEC, NL10276AC30_04L Datasheet - Page 29

• Manufacturer Part Number: NL10276AC30_04L
• Description: TFT COLOR LCD MODULE
• Manufacturer: NEC

20. GENERAL CAUTIONS
(1) Caution when taking out the module
(2) Cautions for handling the module
① Pick up the pouch only, when removing the module from a carrier box.
① As the electrostatic discharges may break the LCD module, handle the LCD module with care against
③ As the surface of polarizer is very soft and easily scratched, use a soft dry cloth without chemicals for
④ Do not pull the interface connectors in or out while the LCD module is operating.
⑤ Put the module display side down on a flat horizontal plane.
⑥ Handle connectors and cables with care.
⑦ When the module is operating, do not lose CLK, Hsync, or Vsync signal. If any one or more of these signals
⑧ The torque for mounting screws should never exceed 0.392 N·m.
⑨ Don’t push or rub the surface of LCD module please.
Because the following statements are very important, please be sure you understand their contents completely.
! ! ! !
②
⑩ Do not give the stress too much on interface connectors. The module may become function deficiency by a
⑪ Do not put front side (display surface side ) of the module on a desk or a table for a long time, because the
If you do, the scratches or the marks like rubbing marks may be left on the surface of the module.
contact defective and damages. Pay attention to handling at the time of matching connector connection and
in the connection condition.
display may become un-uniformity.
electrostatic discharges. Peel protection sheet out from the LCD panel surface as slowly as possible.
cleaning.
is lost, the LCD panel would be damaged.
! ! ! !
Do not touch an inverter on which there is a caution label is stuck while the LCD module is in
operation, because of dangerous high voltage.
CAUTIONS
CAUTION
This figure is a warning that you will get an electric shock if you make a mistake in
operation.
This figure is a warning that you will get hurt if you make a mistake in operation.
As the LCD panel and backlight element are made from fragile glass material, impulse and
pressure to the LCD module should be avoided.
This figure is a warning that you will get hurt and/or the module will be
damaged if you make a mistake in operation.
NEC Corporation
DOD-H-8237
29/33