NL10276BC30-10 NEC, NL10276BC30-10 Datasheet - Page 25

• Manufacturer Part Number: NL10276BC30-10
• Description: TFT COLOR LCD MODULE
• Manufacturer: NEC

6.3.2 Environment
6.3.3 Characteristics
6.3.4 Other
The following items are neither defects nor failures.
patterns.
gases. Keep the product in antistatic pouch in room temperature, because of avoidance for dusts
and sunlight, if customer stores the product.
In order to prevent dew condensation occurring by temperature difference, the product packing
box must be opened after leave under the environment of an unpacking room temperature enough.
Because a situation of dew condensation occurring is changed by the environmental temperature
and humidity, evaluate the leaving time sufficiently. (Recommendation leaving time: 6 hour or
more with packing state)
should be avoided, because it may change color or properties of the polarizer.
The LCD may be seemed luminance non-uniformity, flicker, vertical seam or small spot by display
depending on operating time, and especially low temperature, because the LCD has cold cathode
fluorescent lamps.
saver, if the fixed pattern is displayed on the screen.
backlight.
luminance control frequency of customer's backlight inverter may appear on a display. Set up
luminance control frequency of backlight inverter so that the interference noise does not appear.
All GND and VCC terminals should be used without a non-connected line.
replace backlight lamps.
Pay attention not to insert waste materials inside of products, if customer uses screwnails.
Do not operate in high magnetic field. Circuit boards may be broken down by it.
Use an original protection sheet on the product surface (polarizer). Adhesive type protection sheet
Response time, luminance and color may be changed by ambient temperature.
Do not display the fixed pattern for a long time because it may cause image sticking. Use a screen
The display color may be changed by viewing angle because of the use of condenser sheet in the
Optical characteristics may be changed by input signal timings.
Do not disassemble a product or adjust volume without permission of NEC Corporation.
The interference noise of input signal frequency for this product's signal processing board and
Do not operate or store in high temperature, high humidity, dewdrop atmosphere or corrosive
See "REPLACEMENT MANUAL FOR LAMPHOLDER SET", if customer would like to
Optical characteristics (e.g. luminance, display uniformity, etc.) gradually is going to change
PRELIMINARY DATA SHEET DOD-M-1297 (4th edition)
NL10276BC30-10
25
4