NL128102AC23-02 NEC, NL128102AC23-02 Datasheet - Page 39

• Manufacturer Part Number: NL128102AC23-02
• Description: LCD Module
• Manufacturer: NEC

www.DataSheet4U.net
GENERAL CAUTIONS
(1) Caution when taking out the module
(2) Cautions for handling the module
(3) Cautions for the atmosphere
Next figures and sentence are very important. Please understand these contents as follows.
a) Pick the pouch only, in taking out module from a carrier box.
a) As the electrostatic discharges may break the LCD module, handle the LCD module with care against
b)
c) As the surface of polarizer is very soft and easily scratched, use a soft dry cloth without chemicals for
d) Do not pull the interface connectors in or out while the LCD module is operating.
e) Put the module display side down on that horizontal plane.
f)
g) When the module is operating, do not lose CLK, Hsync or Vsync signal. If any one of these signals is lost,
h) Do not put front side (display surface side) of the module on a desk or a table for a long time, because the
i)
a) Dew drop atmosphere must be avoided.
b) Do not store and/or operate the LCD module in a high temperature and/or high humidity atmosphere.
c) This module uses cold cathod fluorescent lamps.
d) Do not operate the LCD module in a high magnetic field.
Do not touch an inverter, on which is stuck a caution label, while the LCD module is under the operation, because
of dangerous high voltage.
CAUTION
electrostatic discharges.
cleaning.
Handle connectors and cables with care.
the LCD panel would be damaged.
display may become un-uniformity.
The torque to mounting screw should never exceed 0.392 N·m (4 kgf·cm).
Storage in an electro-conductive polymer packing pouch and under relatively low temperature atmosphere
is recommended.
conspicuously at low temperature.
CAUTION
This figure is a mark that you will get an electric shock when you make a mistake to operate.
This figure is a mark that you will get hurt when you make a mistake to operate
As the LCD panel and backlight element are made from fragile glass material, impulse and
pressure to the LCD module should be avoided.
This figure is a mark that you will get hurt and/or the module will have damages when you make
a mistake to operate.
Data Sheet EN0491EJ1V0DS00
Therefore, the life time of lamps becomes short
NL128102AC23-02
www.DataSheet4U.net
39