NL128102BC29_10 NEC, NL128102BC29_10 Datasheet - Page 25

• Manufacturer Part Number: NL128102BC29_10
• Description: Display Module
• Manufacturer: NEC

www.DataSheet.co.kr
6.3.2 Environment
⑥ The product must be installed using mounting holes without undue stress such as bends or twist (See
⑦ Do not press or rub on the sensitive product surface. When cleaning the product surface, use of the
⑧ Do not push nor pull the interface connectors while the product is working.
⑨ Do not locate the lamp cable on the signal processing board. A noise may occur on the display
⑩ Properly connect the plug (backlight side) to adaptable socket (inverter side) without incomplete
⑪ If the lamp cable is attached on the metal part of the product directly, high frequency leak current to
⑫ When handling the product, use of an original protection sheet on the product surface (polarizer) is
⑬ Usually liquid crystals don't leak through the breakage of glasses because of the surface tension of
① Do not operate or store in high temperature, high humidity, dewdrop atmosphere or corrosive
② In order to prevent dew condensation occurring by temperature difference, the product packing
③ Do not operate in high magnetic field. Circuit boards may be broken down by it.
④ This product is not designed as radiation hardened.
outline drawings). And do not add undue stress to any portion (such as bezel flat area). Bends or twist
described above and undue stress to any portion may cause display mura.
Recommended installing method: Ideal plane "A" is defined by one mounting hole (datum point) and
other mounting holes. The ideal plane "A" should be the same plane within ±TBD mm.
cloth with ethanolic liquid such as screen cleaner for LCD is recommended.
image.
connection. After connecting, be careful not to hook the lamp cables because incomplete connection
may occur by hooking the lamp cables. This incomplete connection may cause abnormal operation
of high voltage circuit.
the metal part may occur, then the brightness may decrease or the lamp may not be turned on.
recommended for protection of product surface. Adhesive type protection sheet may change color or
characteristics of the polarizer.
thin layer and the construction of LCD panel. But, if you contact with liquid crystal for the worst,
please wash it out with soap.
gases. Keep the product in packing box with antistatic pouch in room temperature to avoid dusts
and sunlight, when storing the product.
box should be opened after enough time being left under the environment of an unpacking room.
Evaluate the leaving time sufficiently because a situation of dew condensation occurring is
changed by the environmental temperature and humidity. (Recommended leaving time: 6 hours or
more with packing state)
Mounting hole (Datum point)
PRELIMINARY DATA SHEET DOD-PP-0492 (2nd edition)
Product
Mounting hole
Mounting hole
Ideal plane "A"
NL128102BC29-10
25
2
Datasheet pdf - http://www.DataSheet4U.net/