NL8060BC31-17D NEC, NL8060BC31-17D Datasheet - Page 23

• Manufacturer Part Number: NL8060BC31-17D
• Description: Display Module
• Manufacturer: NEC

www.DataSheet.co.kr
19
NEC Corporation
19
19.GENERAL CA
(1) Caution when taking out the module
(2) Cautions for handling the module
(3) Cautions for the atmosphere
19
① Pick the pouch only, when taking out the module from a carrier box.
① As the electrostatic discharges may break the LCD module, handle the LCD module with care against
③ As the surface of polarizer is very soft and easily scratched, use a soft dry cloth without chemicals for
④ Do not pull the interface connectors in or out while the LCD module is operating.
⑤ Put the module display side down on a flat horizontal plane.
⑥ Handle connectors and cables with care.
⑦ When the module is operating, do not lose CLK, Hsync, or Vsync signal. If any one or more of these
⑧ The torque for mounting screws should never exceed 0.294 N･m (3 kgf･cm).
⑨ Don’t push or rub the surface of LCD module please.
① Dew drop atmosphere must be avoided.
② Do not store and/or operate the LCD module in a high temperature and/or high humidity atmosphere.
③ This module uses cold cathode fluorescent lamps. Therefore, the life of lamps becomes short if the
④ Do not operate the LCD module in high magnetic field.
! ! ! !
②
⑩ Do not give the stress too much on interface connectors. The module may become function deficiency by
.GENERAL CA
.GENERAL CA
.GENERAL CAU U U U TION
a contact defective and damages. Pay attention to handling at the time of matching connector connection
and in the connection condition.
electrostatic discharges. Peel protection sheet out from the LCD panel surface as slowly as possible.
cleaning.
signals is lost, the LCD panel would be damaged.
Storage in an anti-static pouch and under the room temperature atmosphere is recommended.
module is operated under the low temperature environment.
Next figures and sentences are very important, please understand these contents as follows.
If you do, the scratches or the marks like rubbing marks may be left on the surface of the module.
! ! ! !
CAUTIONS
CAUTION
This figure is a mark that you will get an electric shock when you make a mistake to
operate.
This figure is a mark that you will get hurt when you make a mistake to operate.
As the LCD panel and backlight element are made from fragile glass material, impulse and
pressure to the LCD module should be avoided.
TION
TIONS S S S
TION
This figure is a mark that you will get hurt and/or the module will have
damages when you make a mistake to operate.
DOD-N-0020
23/27
Datasheet pdf - http://www.DataSheet4U.net/