st10f273m STMicroelectronics, st10f273m Datasheet - Page 95

• Manufacturer Part Number: st10f273m
• Description: 16-bit Mcu With 512 Kbyte Flash Memory And 36 Kbyte Ram
• Manufacturer: STMicroelectronics

ST10F273M
20.5
Refer to the next Figures
and
Watchdog timer reset
When the watchdog timer is not disabled during the initialization, or serviced regularly
during program execution, it will overflow and trigger the reset sequence.
Unlike hardware and software resets, the watchdog reset completes a running external bus
cycle if this bus cycle either does not use READY, or if READY is sampled active (low) after
the programmed wait states.
When READY is sampled inactive (high) after the programmed wait states the running
external bus cycle is aborted. Then the internal reset sequence is started.
Bit P0.12...P0.8 are latched at the end of the reset sequence and bit P0.7...P0.2 are cleared
(that is written at ‘1’).
A Watchdog reset is always taken as synchronous: there is no influence on Watchdog Reset
behavior with RPD status. In case Bidirectional Reset is selected, a Watchdog Reset event
pulls RSTIN pin low: this occurs only if RPD is high; if RPD is low, RSTIN pin is not pulled
low even though Bidirectional Reset is selected.
Refer to the next Figures
and
Figure 26. SW / WDT unidirectional RESET (EA = 1)
30
30
RSTIN
RSTOUT
P0[15:13]
P0[12:8]
P0[7:2]
P0[1:0]
IBUS-CS
(Internal)
FLARST
RST
for bidirectional.
for bidirectional.
26
26
and
and
27
27
1024 TCL
for unidirectional SW reset timing, and to Figures 28,
for unidirectional SW reset timing, and to Figures 28,
not transparent
not transparent
not transparent
transparent
≤ 1 ms
≤ 2 TCL
not t.
not t.
7 TCL
System reset
95/182
29
29