mt48h4m16lf Micron Semiconductor Products, mt48h4m16lf Datasheet - Page 15

• Manufacturer Part Number: mt48h4m16lf
• Description: 64mb 4 Meg X 16 Mobile Sdram Features
• Manufacturer: Micron Semiconductor Products

COMMAND INHIBIT
NO OPERATION (NOP)
LOAD MODE REGISTER
ACTIVE
READ
WRITE
PDF: 09005aef8237ed98/Source: 09005aef8237ed68
64mb_x16_Mobile SDRAM_Y24L_2.fm - Rev. C 10/07 EN
The COMMAND INHIBIT function prevents new commands from being executed by the
SDRAM, regardless of whether the CLK signal is enabled. The SDRAM is effectively dese-
lected. Operations already in progress are not affected.
The NO OPERATION (NOP) command is used to perform a NOP to an SDRAM which is
selected (CS# is LOW). This prevents unwanted commands from being registered during
idle or wait states. Operations already in progress are not affected.
The mode register is loaded via inputs A0–A11, BA0, BA1. See the “Mode Register”
heading in the Register Definition section. The LOAD MODE REGISTER and LOAD
EXTENDED MODE REGISTER commands can only be issued when all banks are idle,
and a subsequent executable command cannot be issued until
The ACTIVE command is used to open (or activate) a row in a particular bank for a
subsequent access. The value on the BA0, BA1 inputs selects the bank, and the address
provided on inputs A0–A11 selects the row. This row remains active (or open) for
accesses until a PRECHARGE command is issued to that bank. A PRECHARGE
command must be issued before opening a different row in the same bank.
The READ command is used to initiate a burst read access to an active row. The value on
the BA0, BA1 inputs selects the bank, and the address provided on inputs A0–A7 selects
the starting column location. The value on input A10 determines whether auto
precharge is used. If auto precharge is selected, the row being accessed will be
precharged at the end of the read burst; if auto precharge is not selected, the row will
remain open for subsequent accesses. Read data appears on the DQ subject to the logic
level on the DQM inputs two clocks earlier. If a given DQM signal was registered HIGH,
the corresponding DQ will be High-Z two clocks later; if the DQM signal was registered
LOW, the DQ will provide valid data.
The WRITE command is used to initiate a burst write access to an active row. The value
on the BA0, BA1 inputs selects the bank, and the address provided on inputs A0–A7
selects the starting column location. The value on input A10 determines whether auto
precharge is used. If auto precharge is selected, the row being accessed will be
precharged at the end of the write burst; if auto precharge is not selected, the row will
remain open for subsequent accesses. Input data appearing on the DQ is written to the
memory array subject to the DQM input logic level appearing coincident with the data.
If a given DQM signal is registered LOW, the corresponding data will be written to
memory; if the DQM signal is registered HIGH, the corresponding data inputs will be
ignored, and a write will not be executed to that byte/column location.
15
Micron Technology, Inc., reserves the right to change products or specifications without notice.
64Mb: 4 Meg x 16 Mobile SDRAM
©2006 Micron Technology, Inc. All rights reserved.
t
MRD is met.
Commands