tda8944j-02 NXP Semiconductors, tda8944j-02 Datasheet - Page 5

• Manufacturer Part Number: tda8944j-02
• Description: Tda8944j 2 X 7 W Stereo Bridge Tied Load Btl Audio Amplifier
• Manufacturer: NXP Semiconductors

Philips Semiconductors
9397 750 06861
Product specification
8.2.1 Output power measurement
8.2.2 Headroom
8.2 Power amplifier
8.3 Mode selection
The power amplifier is a Bridge Tied Load (BTL) amplifier with an all-NPN output
stage, capable of delivering a peak output current of 2 A.
The BTL principle offers the following advantages:
The output power as a function of the supply voltage is measured on the output pins
at THD = 10%; see
supply voltage of 12 V and the maximum available output current: 2 A repetitive peak
current.
Typical CD music requires at least 12 dB (factor 15.85) dynamic headroom –
compared to the average power output – for transferring the loudest parts without
distortion. At V
Average Listening Level (ALL) – music power – without any distortion yields:
The power dissipation can be derived from
respectively 12 dB headroom.
Table 4:
For the average listening level a power dissipation of 4 W can be used for a heatsink
calculation.
The TDA8944J has three functional modes, which can be selected by applying the
proper DC voltage to pin MODE. See
which depend on the supply voltage level. The MODE pin can be driven by a 3-state
logic output stage: e.g. a microcontroller with additional components for DC-level
shifting.
Standby — In this mode the current consumption is very low and the outputs are
floating. The device is in standby mode when (V
the MODE pin is left floating (high impedance). The power consumption of the
TDA8944J will be reduced to <0.18 mW.
Headroom
0 dB
12 dB
•
•
•
•
P
Lower peak value of the supply current
The ripple frequency on the supply voltage is twice the signal frequency
No expensive DC-blocking capacitor
Good low frequency performance.
o(ALL)
= 4 W/15.85 = 252 mW.
Power rating as function of headroom
CC
Rev. 02 — 14 February 2000
= 12 V, R
Figure
Power output (THD = 0.1%)
P
P
o
o(ALL)
= 4 W
8. The maximum output power is limited by the maximum
L
= 252 mW
= 8
and P
Figure 4
o
= 4 W at THD = 0.1% (see
Figure 11 on page 10
and
CC
2 x 7 W stereo BTL audio amplifier
5
Power dissipation (P)
8 W
4 W
0.5 V) < V
for the respective DC levels,
© Philips Electronics N.V. 2000. All rights reserved.
MODE
TDA8944J
for 0 dB
< V
Figure
CC
, or when
6), the
5 of 21