pca9622 NXP Semiconductors, pca9622 Datasheet - Page 15

• Manufacturer Part Number: pca9622
• Description: 16-bit Fm+ I2c-bus 100 Ma 40 V Led Driver
• Manufacturer: NXP Semiconductors

NXP Semiconductors
PCA9622_1
Product data sheet
7.3.8 ALLCALLADR, LED All Call I
7.4 Active LOW output enable input
Once subaddresses have been programmed to their right values, SUBx bits need to be
set to logic 1 in order to have the device acknowledging these addresses (MODE1
register).
Only the 7 MSBs representing the I
register is a read-only bit (0).
When SUBx is set to logic 1, the corresponding I
either an I
Table 12.
Legend: * default value.
The LED All Call I
at the same time (ALLCALL bit in register MODE1 must be equal to 1 (power-up default
state)). This address is programmable through the I
an I
Sub Call.
Only the 7 MSBs representing the All Call I
ALLCALLADR register is a read-only bit (0).
If ALLCALL bit = 0, the device does not acknowledge the address programmed in register
ALLCALLADR.
The active LOW output enable (OE) pin, allows to enable or disable all the LED outputs at
the same time.
The OE pin can be used as a synchronization signal to switch on/off several PCA9622
devices at the same time. This requires an external clock reference that provides blinking
period and the duty cycle.
The OE pin can also be used as an external dimming control signal. The frequency of the
external clock must be high enough not to be seen by the human eye, and the duty cycle
value determines the brightness of the LEDs.
Remark: Do not use OE as an external blinking control signal when internal global
blinking is selected (DMBLNK = 1, MODE2 register) since it will result in an undefined
blinking pattern. Do not use OE as an external dimming control signal when internal global
dimming is selected (DMBLNK = 0, MODE2 register) since it will result in an undefined
dimming pattern.
Address
1Bh
•
•
2
When a LOW level is applied to OE pin, all the LED outputs are enabled.
When a HIGH level is applied to OE pin, all the LED outputs are high-impedance.
C-bus read or write sequence. The register address can also be programmed as a
2
Register
ALLCALLADR
ALLCALLADR - LED All Call I
description
C-bus read or write sequence.
2
C-bus address allows all the PCA9622s on the bus to be programmed
Rev. 01 — 27 March 2009
Bit
7:1
0
Symbol
AC[7:1]
AC[0]
2
C-bus address
2
C-bus subaddress are valid. The LSB in SUBADRx
2
C-bus address register (address 1Bh) bit
2
16-bit Fm+ I
Access Value
R/W
R only
C-bus address are valid. The LSB in
2
C-bus subaddress can be used during
2
C-bus and can be used during either
1110 000*
0*
2
C-bus 100 mA 40 V LED driver
Description
ALLCALL I
address register
reserved
PCA9622
© NXP B.V. 2009. All rights reserved.
2
C-bus
15 of 36